Abstract:Recently, flat heat pipes have been proposed for surface cooling applications to passively extract and recover thermal energy from hot surfaces. For instance, flat heat pipes have recently been proposed as thermal absorber for photovoltaic/thermal (PV/T) applications or for the thermal management of batteries. Following promising surface cooling results, increasing the fundamental knowledge of the two-phase heat transfer taking place inside such multi-channel flat heat pipes can participate to its widespread and lead to further improvement of the technology. Indeed, until now, the investigations have focused on the application only and not on the performance of the flat heat pipe itself. In this regard, this manuscript experimentally and theoretically investigates the thermal performance of a multi-channel flat heat pipe used for surface cooling applications. Heat transfer rates in the range 0–1500 W are studied and their impact on the boiling, condensation, and total thermal resistance of the multi-channel flat heat pipe is measured. In order to predict the thermal performance of the multi-channel flat heat pipe at all heat transfer rates, a theoretical model is proposed, which considers the impact of the multi-channel geometry. This model uses a multi-channel thermal resistance network. Furthermore, an important number of two-phase correlations for pool boiling and condensation are compared with experimental data and the optimum equations are integrated into the multi-channel model. As a result, over the whole range of heat transfer rates investigated, the proposed multi-channel flat heat pipe model was able to predict the boiling, condensation, and total thermal resistances of the heat pipe with an average error of 17.2%, 14.4% and 13.1%, respectively. Finally, the impact of the tilt angle is also studied, and infrared imaging of the flat heat pipe surface is presented.

THE EXPERIMENTAL INVESTIGATION OF PHASE CHANGE HEAT TRANSFER IN A FLAT PLATE HEAT PIPE

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Experimental investigation on heat transfer performance of closed-loop pulsating heat pipe with large inner diameter

Investigation on Transient Behaviors of Flat Plate Heat Pipes

Experimental Research on Heat Transfer Performance of 3 mm Closed Pulsating Heat Pipe

Experimental Research on the Start-Up Characteristics and Heat Transfer Performance of Pulsating Heat Pipes with Rectangular Channels

Experimental Study on the Thermo-Hydrodynamic Characteristics of a Nitrogen Pulsating Heat Pipe

Experimental Study on Heat Transfer Performance Using a Hybrid Cooling Method Combined of a Flat-Plate Heat Pipe and Spray Cooling

Experimental Study on a Hydrogen Pulsating Heat Pipe in Different Heating Modes

Study on Heat Transfer Performance of an Aluminum Flat Plate Heat Pipe with Fins in Vapor Chamber

Thermo-hydrodynamic Analysis of a Nitrogen Flat-Plate Pulsating Heat Pipe Using CFD Modeling and Visualization Experiments

Experimental Study on a Hydrogen Closed-Loop Pulsating Heat Pipe with Two Turns

Numerical Study of the Thermal Performance of a Hydrogen Pulsating Heat Pipe

Design and Experimental Analysis of Grooved Flat Aluminum Heat Pipe

Numerical Investigation on Pulsating Heat Pipes with Nitrogen or Hydrogen

Experimental Study on a Hydrogen Closed Loop Pulsating Heat Pipe with Different Adiabatic Lengths

STUDY ON TWO-PHASE FLOW AND TEMPERATURE UNIFORMITY CHARACTERISTICS OF MICROCHANNEL HEAT PIPE

Visualization Study on the Enhancement of Heat Transfer for the Groove Flat-Plate Heat Pipe with Nanoflower Coated CuO Layer

Experimental investigation of a flat plate heat pipe performance using IR thermal imaging camera

Experimental and theoretical investigation of the influence of heat transfer rate on the thermal performance of a multi-channel flat heat pipe