Abstract:Cu and unoxidized graphene composite films were prepared by electroplating under room temperature. Graphene was added to the electrolyte of Cu to form composite materials to improve the performance of Cu for interconnection. Composite electrolyte containing high concentration of graphene (up to 0.5 g/L) was prepared by adding CTAB as surfactant. And ultrasound was also used to increase dispersion degree and reduce graphene agglomeration in electrolyte. Average coefficient of thermal expansion (CTE) of the composite films determined by thermo-mechanical analysis (TMA) shows a decrease from 17.3 ppm/K to 14.2 ppm/K from 260 K to 320 K, which reduce CTE by 18 % compared with Cu. CTE of the composite materials can be reduced to 10 ppm/K at 243 K, which is only 60 % of CTE of Cu. The thermal conductivity of the composite materials measured by phase sensitive transient thermo-reflectance (PSTTR) technique shows an improvement from 385 W/m.K to 468 W/m.K. CTE and thermal conductivity of the composite materials both decrease with the increase of current density. And they also both increase with the increase of graphene concentration. The composite materials also show good mechanical properties. The average hardness is 2.5 GPa, which is about 2 times of Cu. And the average elastic modulus is 145 GPa, which is 38 % higher than that of Cu. The resistivity of the composite materials is basically equivalent to that of pure Cu. Result of the experiment proved that the composite materials have better performance under low temperature conditions. The improvement of material properties makes composite materials have good application prospects for 3D interconnection in the near future.

Preparation, Microstructure and Properties of In-Situ Synthesized Graphene-Copper Composite

A novel approach for in-situ preparation of copper/graphene composite with high hardness and high electrical conductivity

Microstructure and mechanical properties of graphene-reinforced copper matrix composites prepared by in-situ CVD, ball-milling, and spark plasma sintering

Microstructure and properties of bulk copper matrix composites strengthened with various kinds of graphene nanoplatelets

Microstructure and Properties of a Graphene Reinforced Cu–Cr–Mg Composite

Microstructure and properties of copper matrix composites reinforced with Cu-doped graphene

Fabrication of graphene/Cu composites with in-situ grown graphene from solid carbon source

In-situ synthesized graphene reinforced copper matrix composites with enhanced thermal properties and corrosion resistance

Preparation and Characterization of Electroplated Cu/Graphene Composite

Preparation of graphene/copper nanocomposites by ball milling followed by pressureless vacuum sintering

High strength and conductivity copper matrix composites reinforced by in-situ graphene through severe plastic deformation processes

Preparation and Properties of Cu-Plated Graphene/Cu Composites

W-Cu Composites Reinforced by Copper Coated Graphene Prepared Using Infiltration Sintering and Spark Plasma Sintering: A Comparative Study

The improved softening resistance and high electrical conductivity of the 3D graphene enhanced copper-based composite fabricated by liquid carbon source

Study on the microstructure and properties of Cu-graphite-Cr3C2 composites prepared by in-situ reactive synthesis

Investigation on the novel copper-based composite conductors synergistically improved by in-situ generated graphene and nanoparticles

A high strength and high electrical conductivity graphene/Cu composite with good high-temperature stability

Effect of graphene on microstructure and properties of Gr/CuCr10 composites

Effect of Powder Preparation Techniques on Microstructure, Mechanical Properties, and Wear Behaviors of Graphene-Reinforced Copper Matrix Composites

Effect of graphene addition on properties of Cu-based composites for electrical contacts

Surface modification on copper particles toward graphene reinforced copper matrix composites for electrical engineering application