Abstract:Cu and unoxidized graphene composite films were prepared by electroplating under room temperature. Graphene was added to the electrolyte of Cu to form composite materials to improve the performance of Cu for interconnection. Composite electrolyte containing high concentration of graphene (up to 0.5 g/L) was prepared by adding CTAB as surfactant. And ultrasound was also used to increase dispersion degree and reduce graphene agglomeration in electrolyte. Average coefficient of thermal expansion (CTE) of the composite films determined by thermo-mechanical analysis (TMA) shows a decrease from 17.3 ppm/K to 14.2 ppm/K from 260 K to 320 K, which reduce CTE by 18 % compared with Cu. CTE of the composite materials can be reduced to 10 ppm/K at 243 K, which is only 60 % of CTE of Cu. The thermal conductivity of the composite materials measured by phase sensitive transient thermo-reflectance (PSTTR) technique shows an improvement from 385 W/m.K to 468 W/m.K. CTE and thermal conductivity of the composite materials both decrease with the increase of current density. And they also both increase with the increase of graphene concentration. The composite materials also show good mechanical properties. The average hardness is 2.5 GPa, which is about 2 times of Cu. And the average elastic modulus is 145 GPa, which is 38 % higher than that of Cu. The resistivity of the composite materials is basically equivalent to that of pure Cu. Result of the experiment proved that the composite materials have better performance under low temperature conditions. The improvement of material properties makes composite materials have good application prospects for 3D interconnection in the near future.

The improved softening resistance and high electrical conductivity of the 3D graphene enhanced copper-based composite fabricated by liquid carbon source

Preparation and Characterization of Electroplated Cu/Graphene Composite

A novel approach for in-situ preparation of copper/graphene composite with high hardness and high electrical conductivity

Superior electrical conductivity-strength combination of an in-situ fabricated La 2 O 3 -doped copper/graphene composite conductor

A high strength and high electrical conductivity graphene/Cu composite with good high-temperature stability

Microstructure and Properties of a Graphene Reinforced Cu–Cr–Mg Composite

Enhanced Electrical Conductivity and Tensile Strength of Cu/Single-Layer Graphene/Cu Nanomaterials

Facile fabrication of layer-structured graphene/copper composite with enhanced electrical and mechanical properties

Fabrication and characterization of copper and copper alloys reinforced with graphene

Investigation on the novel copper-based composite conductors synergistically improved by in-situ generated graphene and nanoparticles

In-situ graphene enhanced copper wire: A novel electrical material with simultaneously high electrical conductivity and high strength

Fabrication of Cu/Al/Cu Laminated Composites Reinforced with Graphene by Hot Pressing and Evaluation of Their Electrical Conductivity

A high strength and high electrical conductivity copper based composite enhanced by graphene and Al2O3 nanoparticles

Effect of graphene addition on properties of Cu-based composites for electrical contacts

High strength and conductivity copper matrix composites reinforced by in-situ graphene through severe plastic deformation processes

High strength and high electrical conductivity in copper reinforced with intra-/inter-granular graphene in-situ exfoliated from graphite

Surface modification on copper particles toward graphene reinforced copper matrix composites for electrical engineering application

Graphene/copper composite films: Interface regulation for enhanced electrical performance

Copper coated graphene reinforced aluminum composites with enhanced mechanical strength and conductivity

Superior mechanical properties and wear resistance of copper/graphite metallic composites fabricated with fibrous copper powder

In-situ synthesized graphene reinforced copper matrix composites with enhanced thermal properties and corrosion resistance