Abstract:Si-modified NiAl coating has been studied by researchers due to its good performance in high temperature corrosive environment, but the effect of Si content on the high temperature oxidation resistance of the aluminide coatings has been seldom studied. To figure out this issue, three modified NiAl coatings with different Si contents were prepared by varying the Si contents 8wt%, 17wt% and 30 wt% in the slurry. Phase structures and microstructures of the simple NiAl coatings and three Si-modified NiAl coatings before and after oxidation were analyzed by XRD, SEM and EPMA, etc. The results show that the delta-Ni2Al3 and ss-NiAl are the primary phases of the four aluminide coatings. Si mainly locates in the upper zone of the Si-modified NiAl coatings in the form of silicides as CrSi2, Cr5Si3 and Ni2Si. After oxidation at 1000. for 500 h, the simple NiAl coating has the maximum mass gain of 1.93 mg/cm(2), while the Si-modified NiAl coating with Si content of 8wt% has the smallest mass gain. The dopant of Si into NiAl coatings can promote the formation of protective alpha-Al2O3 film, retard the outward diffusion of refractory metal elements and improve the surface quality of the oxide film, resulting in reduced oxidation rate. However, the addition of Si reduces the Al content on the surface layer of the coating and may make the coating insufficient of ss phase to maintain the selective oxidation of Al in the later period of long- time oxidation. Therefore, when the Si content is 8wt%, the Si-modified NiAl coating possesses the best oxidation resistance.

High Temperature Oxidation Behavior of Nb-Ti-Al Alloy and Its Silicide Coating

Thermal Oxidation Behaviour of Ti6Al7Nb and Ti6Al4V Alloys

High-Temperature Oxidation Behavior of Plasma Surface Nb-Cr-(Si) Alloying System on γ-TiAl

Study on the Oxidation Behavior of TiB2-CeO2-Modified (Nb,Mo,Cr,W)Si2 Coating on the Surface of Niobium Alloy

High-temperature oxidation behaviour of laser in situ synthesised Ti-Al-Cr-Nb alloy coating on Ti-6Al-4V

Structure and High-Temperature Oxidation Performance of Si-Co Diffusion Coatings Prepared on a TiAl-Nb Alloy

The oxidation behavior and interfacial reaction between SiO 2 coating and Ti45Al8.5Nb alloy

Cyclic oxidation behavior of Nb/Mn/Si alloying beta-gamma TiAl alloys

A novel composite Si-Mo-Ti coating with Ti concentration gradient for Nb-Si based ultrahigh temperature alloy prepared by slurry sintering

Mechanical Properties and Oxidation Characteristics of TiNiAl(Nb) Intermetallics

Effect of Ni in SiO 2 coating on the oxidation resistance of TiAl alloy at 900 °C

Development and oxidation behavior of high entropy silicide (NbMoTaWV)Si2 coatings on NbMoTaWV alloy

High Temperature Oxidation Behaviors of Al/Cr Composite Coating on Ti2AlNb Alloy

High-Temperature Oxidation Resistance of High-Nb TiAl-Based Alloy

Structural and High-Temperature Oxidation Performance of Al-Co-Y Co-deposited Coatings on a TiAl-Nb Alloy at Low Temperatures

Improving oxidation resistance of γ-TiAl based alloy by depositing TiAlSiN coating: Effects of silicon

Formation and oxidation behavior of refractory high-entropy silicide (NbMoTaW)Si2 coating

High temperature protection of a novel TiB 2 -modified (Nb,Mo,Cr)Si 2 ceramic coating on Nb-based alloy

High-Temperature Oxidation of NbTi-Bearing Refractory Medium- and High-Entropy Alloys

Initial Oxidation Behavior in Air of TiAl-2Nb and TiAl-8Nb Alloys Produced by Electron Beam Melting

High Temperature Oxidation Resistance and Degradation Mechanism of Al-Si Coatings on Nickel-Based Superalloy at 1000.