Abstract:The forming quality of profiled ring rolling not only encompasses macroscopic accuracy but also emphasizes the microstructure. Due to the multiple process parameters and complex metal flow during profiled ring rolling, the various forming defects are difficult to control and difficult to study theoretically. The objective of this study is to establish a comprehensive method for evaluating the forming quality of profiled rings, which considers both the macroscopic forming accuracy and the microstructure. Firstly, the synthetic size factor was defined, and the evolutionary relation between the section forming rate and the diameter growth rate of E-section ring rolling was analyzed in detail. The synthetic size factor can be used to describe the dimensional evolution and evaluate the forming accuracy of the profiled ring rolling process. Taking into full consideration the features of intermittent deformation in local areas, a microstructure evolution model of the Inconel718 alloy during E-section ring rolling, which can accurately predict the recrystallization volume fraction and average grain size of the final ring, was established. Then, combined with finite element simulation, the influence of the rotation speed of the driving roll on the macro-size evolution and microstructure was systematically analyzed. The results indicate that there is often a discrepancy between dimensional accuracy and microstructure uniformity in the optimization trend. For instance, the higher the rotation speed of the driving roll is, the more uniform the microstructure is, but the more difficult it is for the section profile to form. Finally, combined with response surface methodology (RSM), multi-parameter optimization was carried out with section forming accuracy and grain uniformity as the optimization objectives. By using the optimal parameters, an E-section ring with a complete profile and a uniform microstructure was obtained, with a maximum prediction error of the recrystallization volume fraction lower than 5%. The results show that the macroscopic and microscopic quality evaluation methods proposed in this study, as well as the optimization method combining RSM, can be effectively applied to the process optimization of profiled ring rolling.

Numerical simulation and process optimization on radial-axial rolling process for L-shaped cross-sectional ring

A Hybrid of Theory and Numerical Simulation Research for Virtual Rolling of Double-Groove Ball Rings

Multi-objective optimization of parametric design for profile ring rolling process based on residual stress control

Numerical simulation and experimental study on geometry variations and process control method of vertical hot ring rolling

A Numerical Simulation Method for Calculating the Roundness of Cold Rolling Ring

Evaluation Methods and Coupled Optimization at Macro- and Micro-Scales for Profiled Ring Rolling of Inconel718 Alloy

Analytical calculation model for radial-axial coordinated feed strategy in large-scale flat ring rolling based on ultimate bending moment

Study on Roll Forming Process Simulation and Roll Diameters Optimization

Three-dimensional rigid–plastic finite element simulation for the two-roll cross-wedge rolling process

An innovative spinning-rolling process and its intelligent FE modelling for big-tapered profiled ring disk

Buckling Defect Optimization of Constrained Ring Rolling of Thin-Walled Conical Rings with Inner High Ribs Combining Response Surface Method with FEM

Study on Cavity Filling Defects and Tensile Properties of L-Shaped Profiled Rings

Implementing approach of rolling process for inner spline sleeve with medium diameter: radial-feed rolling and through-feed rolling

The Numerical Simulation of Wheel Rim Roll Forming

Theoretical Analysis and Numerical Simulation of External Spline Cold Rolling

Finite element analysis on axial-pushed incremental warm rolling process of spline shaft with 42CrMo steel and relevant improvement

Numerical Analysis and Parameter Optimization of Wear Characteristics of Titanium Alloy Cross Wedge Rolling Die

Numerical and experimental analysis of defects control in cross wedge rolling for titanium alloy workpieces

Quantitative Design Methodology for Flat Ring Rolling Process

Study and improvements on the rolling loads of axial incremental rolling process for spline shaft based on finite element method

Numerical Model Simulation of the Double-Roll Rotary Forging of Large Diameter Thin-Walled Disk