Abstract:Springback is one of the most important problems that should be compensated in sheet metal forming process with the increasing application of advanced high strength steels and light-weight alloys. In the finite element analyses for the springback, accurate modeling of Bauschinger effect, transient behavior and permanent softening under cyclic loading has been recognized as the most critical hardening behavior in the constitutive modeling aspect. However, if parts of these hardening behavior are not well modelled, is the accuracy of springback prediction seriously deteriorated? To answer this question, in this paper the significance of Bauschinger effect and transient behavior, permanent softening and unloading modulus in springback prediction were estimated using the springback problem of U-draw/bending simulations proposed at Numisheet2011 Benchmark. A recent anisotropic non-linear kinematic (ANK) model [Zang S, Guo C, Thuillier S, Lee M. A model of one-surface cyclic plasticity and its application to springback prediction. Int J Mech Sci 2011;53:425–35.] was adopted to estimate the significance of hardening behavior and unloading modulus because of its special feature. The ANK model can predict exactly the same monotonous stress–strain curves for different hardening schemes, while different Bauschinger effect and transient behavior under one-dimensional cyclic loading can be also modelled. This feature is quite suitable to quantitatively evaluate the effects of the aforementioned hardening behaviors in springback prediction. Initial anisotropy is described by the anisotropic yield function Yld2000-2d. The unloading behavior is also considered by defining Young's modulus as a function of equivalent plastic strain. Several quantitative analyses were carried out to distinguish the effect of each hardening component and unloading elastic modulus scheme. Finally, the predicted springback by different models were compared with experiments for both as-received and pre-strained DP780 steel sheets.

Study on the springback law of high strength steel U-shaped part considering Bauschinger effect

Springback after the Lateral Bending of T-Section Rails of Work-Hardening Materials

Springback prediction of advanced high strength steel part based on Yoshida-Uemori hardening model

Study on Process Parameters and Springback Rule for Stamping of High Strength Steel Sheet

Springback Prediction Using the Split-Ring Test Based on A Combined Anisotropic Hardening Model

Evaluating the Significance of Hardening Behavior and Unloading Modulus under Strain Reversal in Sheet Springback Prediction

Analysis on the Effects of Numerical Simulation Precision on Springback Prediction

Springback prediction of stamping GH3536 alloy sheet with complex surface

Analysis of springback for multiple bending considering nonlinear unloading-reloading behavior, stress inheritance and Bauschinger effect

Numerical Simulation and Experimental Validation of Distortional Springback of Advanced High-Strength Steel Sheet Metal Forming

Numerical springback prediction for high-strength aluminum alloys based on the sheet metal upsetting test

An Analytical Model for Predicting Springback and Side Wall Curl of Sheet after U-bending

An Analytical Model for Predicting Sheet Springback after V-bending

Analysis of Mechanism of Springback in 22MnB5 Super-high Strength Steel Forming

Study of the Influence of Element Size and Number of Integration Points on Accuracy of Sheet Springback Prediction

A new predicting model study on U-shaped stamping springback behavior subjected to steady-state temperature field

Eliminating Springback Error in U-Shaped Part Forming by Variable Blankholder Force

Sensitivity Analysis of Effect of Material Properties to Spring-back of High Strength Steel

Investigation into Springback Characteristics of Two Hss Sheets During Cold V-Bending

The Control of Springback for Forming of Advanced Ultra High Strength Martensitic Steel

Adaptive multiple scale meshless simulation on springback analysis in sheet metal forming