Deformation behavior of deep drawing of 5A06 aluminum alloy plate

ZHANG Zhi-chao,XU Yong-chao,YUAN Shi-jian

DOI: https://doi.org/10.19476/j.ysxb.1004.0609.2015.07.004

2015-01-01

The Chinese Journal of Nonferrous Metals

Abstract:The deformation behavior of deep drawing of plate is different from that of sheet metal because of the obvious stress gradient along the thickness direction induced from bending effect. The finite element analyses were performed to investigate the radial stress during the plate deep drawing process,and the maximum radial stress and its location along die radius were observed, the effect of die radius on radial stress was discussed. An experiment was conducted on the deep drawing of 5A06 aluminum plate with thickness of 4.5 mm into the cups with diameter of 450 mm. The results show that the maximum radial stress generates at the transition area between the die radius and cylinder wall, and the fracture occurs at the same place. With increasing the die radius the maximum radial stress decreases. And cracks initiate at the transition area between the cylinder wall and die radius. The maximum radial stress decreases and the fracture is delayed when the die radius increases, as a result, the limited punch stroke at the relative die radius of 12 is improved by about 83% compared with that at the relative die radius of 4.5.