Abstract:The evolution of the microstructure of P92 steel during heat processing has a significant effect on the final performance of steel products and is thus an area of critical interest. Accordingly, the grain growth behavior of austenite and δ-ferrite changes in P92 steel is comprehensively investigated in this study through thermodynamic calculations and physical simulation. The results show that the AC1, AC3 and γ–δ transformation temperatures of P92 steel are 841 °C, 878 °C and 1095 °C, respectively, which are comparable to the measured values of 850 °C, 879 °C and 1175 °C, respectively. When the temperature exceeds the AC1 temperature, the austenite grain size increases with increasing temperature and longer holding times, and the growth rate of austenite grains increases with higher temperatures but decreases with holding time at a certain temperature. A model that shows the austenite grain growth kinetics is established: Dn − D 0 n = 2.03 × 1016exp(− 498,770/RT)t, in which the time exponent n decreases from 4.52 to 2.11 with an increase in temperature from 1000 °C to 1200 °C due to the reduced pinning effect resultant of the dissolution of precipitates, M23C6, VX and NbX at 887 °C, 1073 °C and 1200 °C, respectively. The formation of δ-ferrite at 1200 °C when held for 600 s and 1300 °C when held for 60 ~ 600 s causes a smaller austenite grain size. The relationship between the evolution of the microstructure of P92 steel and the mechanical properties is also studied. The results show that the prior austenite grain size has an inverse relationship with impact energy and ultimate tensile strength at 620 °C, while the presence of soft δ-ferrite leads to a reduction in the microhardness, impact energy and ultimate tensile strength at 620 °C.

Room temperature tensile properties of P92 steel based on minimallyinvasive technique

Study on High Temperature Tensile Test of P92 Material Based on Minimally Invasive Technique

Study on High Temperature Creep Test of P92 Material Based on the Minimally Invasive Technique

Effect of High Temperature Exposure and Strain Rate on Mechanical Properties of High-Strength Steel Rebars

DSI-based Studies of the Effects of High-temperature Aging on Local Mechanical Properties of HR3C/T92 Dissimilar Steel Welded Joint

Effect of Fatigue Load on High-Temperature Tensile Properties of P92 Steel

Quantitative description between pre-fatigue damage and residual tensile properties of P92 steel

Deterioration of Mechanical Properties of Novel Constructional Steel Material at Elevated Temperatures

Experimental investigation of cold-formed steel material at elevated temperatures

Characterization of Low Cycle Fatigue of Ferritic–Martensitic P92 Steel: Effect of Temperature

Behavior of High Strength Structural Steel at Elevated Temperatures

Optical Strain Measurement and Microfractography of the Fractures of Armstal 550 Steel after Temperature Tensile Tests

Effect of Thermo-Mechanical Treatment on Microstructure and Mechanical Properties of P92 Heat Resistant Steel

Application of 3D digital image correlation for the measurement of the tensile mechanical properties of high-strength steel

Experimental Analysis of Mechanical Properties of Thick Plate in Steel Structure at Low Temperature

A new small punch test method to predict tensile properties of steels: Representative stress–strain method

Investigation on Microstructural Evolutions and Mechanical Properties of P92 Steel During Thermal Processing

Study on Mechanical Properties of S30403 Based on Small Punch Test Technique at Elevated Temperature

Effect of Varying Heat Treatment Regimes on Microstructure and Mechanical Properties of P92 Steel Welds

A Novel Small Specimen Testing Method Based on a Pneumatic Bulging Test: Measurement of Tensile Properties at High Temperatures

Optimizing Parallel Section Length For Small Tensile Specimen With Fabrication Non-Uniformity In Thickness