Abstract:The health monitoring of cylindrical elements is particularly important for the safe operation of industrial production, because cylinders bear a lot of support and transmission work. Normal non-destructive evaluation techniques need special designs to suit high curvature surfaces of cylinders. Laser ultrasonic (LU) method can provide a remote and non-destructive inspection solution to solid cylinders due to its flexible adaptability to complex structures and strong penetration depth. However, constrained by the common problems of optical detection systems, the detected ultrasonic signals will suffer low signal-to-noise ratio and bad resolution from poor sample surface quality. Thus, a modified synthetic aperture focusing technique (SAFT) optimized for cylindrical components is proposed to improve the detectability of LU on small and buried defects. Mode conversion wave signals obtained by multiple separate excitations are used in SAFT imaging for the reconstruction of the defects under surface profile correction. To reduce the influence of incident waves such as direct surface acoustic wave, besides common difference method, adjacent wave subtraction algorithm based on cross-correlation is used for signal preprocessing, suppressing the incident waves and exaggerating the mode conversion waves. In numerical simulation, internal defects with diameters from 0.6 to 0.2mm with various buried depths are visualized and accurately located via the optimized SAFT algorithm using mode conversion waves. For validation, a circumferential scanning system is established in LU experiment and internal defects from 0.8 to 0.4mm in diameter inside solid cylinders are successfully detected with precise location. The results elucidate the reliability of characterizing the location of small internal buried defects in solid cylinder structures through LU-SAFT imaging.

The Inquiry of Improving Quantitative Accuracy of Flaw Length in TOFD Technique Based on SAFT

Ultrasonic Guided Wave-Based Circumferential Scanning of Plates Using a Synthetic Aperture Focusing Technique

Frequency Domain Synthetic Aperture Focusing Technique for Variable-Diameter Cylindrical Components.

Enhancing Ultrasonic Time-of-flight Diffraction Measurement Through an Adaptive Deconvolution Method

Study on Ultrasonic C-Scan Technique for Variation Thickness Aviation Forged Piece

A flaw echo detection method based on S-transformation and time-frequency spectrum spatial filtering

Detecting features of defect metal based on laser ultrasonic technique

Application of Computer Finite Element Simulation to the Quantitative Inspection of Flaw MFL

Numerical Study of Length and Angle Gauging for Subsurface-Inclined Cracks Based on Reflected Surface Waves with Laser Ultrasonic Technique

Wavenumber-Domain Fast Reconstruction Technique Using Ultrasonic Scanning for Transverse Wave Imaging

Characterization of internal defects in cylindrical components using laser ultrasonic method with a modified SAFT algorithm

Enhancing Time-of-Flight Diffraction (TOFD) Inspection through an Innovative Curved-Sole Probe Design

Three-dimensional reconstruction of transverse hole defect in plate based on TOFD inspection

Time-domain Approach for Ultrasonic Non-destructive Detection Based on Synthetic Aperture Focusing Technique

Width and Depth Gauging of Rectangular Subsurface Defects Based on All-Optical Laser-Ultrasonic Technology

Finite element based research on ultrasonic spectral characteristic of inner wall defect of metal materials

Reducing Dead Zone in Ultrasonic Time-of-Flight Diffraction (TOFD): A Review

A modified synthetic aperture focusing algorithm used for transmission detection based on laser ultrasonics method

Defect detection using the phased-array laser ultrasonic crack diffraction enhancement method

Quantitative Analysis on Parameters of a Defect with Speckle Interferometry and Finite Element Optimization Method

Non-destructive laser-ultrasonic Synthetic Aperture Focusing Technique (SAFT) for 3D visualization of defects