Abstract:Iron is the most common and detrimental impurity in aluminum casting alloys and has long been associated with an increase in casting defects. While the negative effects of iron are clear, the mechanism involved is not fully understood. It is generally believed to be associated with the formation of Fe-rich intermetallic phases. Many factors, including alloy composition, melt superheating, Sr modification, cooling rate, and oxide bifilms, could play a role. In the present investigation, the interactions between iron and each individual element commonly present in aluminum casting alloys, were investigated using a combination of thermal analysis and interrupted quenching tests. The Fe-rich intermetallic phases were characterized using optical microscope, scanning electron microscope, and electron probe microanalysis (EPMA), and the results were compared with the predictions by Thermocalc. It was found that increasing the iron content changes the precipitation sequence of the β phase, leading to the precipitation of coarse binary β platelets at a higher temperature. In contrast, manganese, silicon, and strontium appear to suppress the coarse binary β platelets, and Mn further promotes the formation of a more compact and less harmful α phase. They are therefore expected to reduce the negative effects of the β phase. While reported in the literature, no effect of P on the amount of β platelets was observed. Finally, attempts are made to correlate the Fe-rich intermetallic phases to the formation of casting defects. The role of the β phase as a nucleation site for eutectic Si and the role of the oxide bifilms and AlP as a heterogeneous substrate of Fe intermetallics are also discussed.

Fracture Phenomenon of Needle-like Iron Phase in Al-Si Alloy

Structural Evolution of Topologically Closed Packed Phase in a Ni-based Single Crystal Superalloy

Hexagonal Iron Phase Study in Aluminum-Silicon Alloy

Multi-component Phase-Field Simulation of Microstructural Evolution and Elemental Distribution in Fe–Cu–Mn–Ni–Al Alloy

Solidification Behaviors and Microstructure Morphology of Iron Phase in Al-Si Alloys with Higher Iron Content

Fracture behavior of deposited AlSiFe alloy

The characterization of Fe-rich phases in a high-pressure die cast hypoeutectic aluminum-silicon alloy

Effect of Cooling Rate on the Microstructure Evolution and Mechanical Properties of Iron-Rich Al–Si Alloy

Three stage yielding phenomenon in a NiAlFe alloy

Fracture mechanism of the phase in tensile deformation of a nickel-based superalloy

Multi-Dimensional Revealing the Influence Mechanism of the δ Phase on the Tensile Fracture Behavior of a Nickel-Based Superalloy on the Mesoscopic Scale

Hierarchical phase separation behavior in a Ni-Si-Fe alloy

Exploring the Relationship between the Structural Characteristics and Mechanical Behavior of Multicomponent Fe-Containing Phases: Experimental Studies and First-Principles Calculations

Fracture mechanism of the δ phase in tensile deformation of a nickel-based superalloy

Effect of Δ-Al3cuni Phase and Thermal Exposure on Microstructure and Mechanical Properties of Al-Si-Cu-Ni Alloys

Modification of Silicon Microsegregation in Solid-Solution-Strengthened Ductile Iron by Alloying with Aluminum

Phase Field Simulation of Alloying Element Segregation During Solidification of DD5 Nickel-Base Single Crystal Superalloy

Iron-rich intermetallic phases and their role in casting defect formation in hypoeutectic Al-Si alloys

Effect of incoherent phase boundary on fracture mechanism of sintered Nd-Fe-B alloy

Phase transformation from phase to S phase at grain boundary during annealing in rapidly-solidified Al-Zn-Mg-Cu alloy

Improving strength-ductility balance of a brittle Al-doped FeCrNi multi-principal element alloy by introducing a heterostructure with hard phase enveloping soft phase