Abstract:Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, Ahead of Print. Spiral bevel gear is widely used in the automotive and aerospace manufacturing industries, and the machining process is complex and the material is difficult to cut. The characteristics of high hardness, strong chemical reactivity and poor heat dissipation make the machinability of 20CrMnTi poor for face-hobbing machining of spiral bevel gear. In the process of cutting, there are some problems such as severe tool wear, poor machining quality and low machining efficiency caused by higher cutting force and higher cutting temperature. Therefore, it is necessary to study and analyze the wear experiment of the cutting tools of spiral bevel gear for face-hobbing deeply. Firstly, under the single factor experimental conditions, the wear patterns of inside blade and outside blade are observed and analyzed at different rotational speeds, and the tool wear conditions are detected and measured analysis. Secondly, the tool wear morphology and element distribution of rake face and flank face of inside blade and outside blade are analyzed by scanning electron microscope and energy spectrometer, and the tool wear mechanism for face-hobbing of spiral bevel gear is discussed in depth. The results demonstrate that chipping and fracture are the main patterns of tool wear; the tool wear mechanism are mainly embodied in adhesive wear, diffusion wear and oxidation wear. The tool wear is mainly distributed on the main cutting edge, top edge and corner radius, and the top edge and corner radius are more seriously worn. The research results can provide an effective basis for exploring the tool wear mechanism and improving the tool life, and provide technical support for the design and development of gear machining tools.

Analysis of High Temperature Wear Process Mechanism of Cemented Carbide Tool

High-temperature mechanical properties of a cemented carbide cutter during extra-heavy cutting process

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Study on the Orthogonal Cutting Process of Al7050T7451 with Uncoated and Coated Tools

Temperature Experiment and Parameter Optimization of Cemented Carbide Tool in Milling 508III Steel

Analysis on wear patterns and mechanisms of carbide tool for face-hobbing of spiral bevel gear

STUDY ON THE WEAR PERFORMANCES OF CERAMIC TOOLS FOR MACHINING 304 STAINLESS STEEL

Inlfuences of Material Tool and Tool Wear on Cutting Temperature of Turning Titanium Matrix Composites

Design for Manufacturing of Cemented Carbide Coated Components Toward High Wear and Impact Resistance Performance

Adhering Failure and Optimization of Cemented Carbide Inserts for the Heavy-Duty Cutting of High-Strength Steel Forgings

Experiment Study on Cutter Disrepair Principle and Optimization for Machining Heat-Resistant Steel

Study on the adhering failure mechanism of cemented carbide inserts and element diffusion model during the heavy-duty cutting of water chamber head

Multi-pattern failure modes and wear mechanisms of WC-Co tools in dry turning Ti–6Al–4V

Analysis of the effect of tool geometry on the cutting process of polycrystalline Fe-Cr-W alloy based on molecular dynamics simulation

Numerical Simulation of Combustion Resistant Titanium Alloy Wear Behavior at High Temperature Fields

Simulation and experimental study of tool wear in high-speed dry gear hobbing

Analysis of Tool Wear in GH4169 Material Milling Process

Frictional Study on 30CrNi2MoVA Steel Based on Experiments and Finite Element Simulation: Wear Prediction

Cutting Performance and Wear/Damage Characteristics of PCBN Tool in Hard Milling

Study on wear mechanism of milling cutter and hole-making quality in ball helical milling process

Some Factors Affecting Wear on Cemented Carbide Tools