Abstract:The large capacity servo press is traditionally realized by means of redundant actuation, however there exist the over-constraint problem and interference among actuators, which increases the control difficulty and the product cost. A new type of press mechanism with parallel topology is presented to develop the mechanical servo press with high stamping capacity. The dynamic model considering gravity counterbalance is proposed based on the virtual work principle, and then the effect of counterbalance cylinder on the dynamic performance of the servo press is studied. It is found that the motor torque required to operate the press is a lot less than the others when the ratio of the counterbalance force to the gravity of ram is in the vicinity of 1.0. The stamping force of the real press prototype can reach up to 25 MN on the position of 13 mm away from the bottom dead center. The typical deep-drawing process with 1 200 mm stroke at 8 strokes per minute is proposed by means of five order polynomial. On this process condition, the driving torques are calculated based on the above dynamic model and the torque measuring test is also carried out on the prototype. It is shown that the curve trend of calculation torque is consistent to the measured result and that the average error is less than 15%. The parallel mechanism is introduced into the development of large capacity servo press to avoid the over-constraint and interference of traditional redundant actuation, and its dynamic characteristics with gravity counterbalance are presented.

Investigation on Inertial Force Balance Assembly Units and Their Dynamic Characteristics of A High Speed Press

The Design Study of Single Plane Vertical Hard Bearing Dynamic Balancing Machine

Study of Automatic Dynamic Balancing System for Engine Crankshaft

The Study of Dynamic Balancing for High-Speed Presses

The Design of Dynamic Balancing Machine Based on Finite Element Analysis

Design and Implementation of Automatic Balancing Machine for Pump Impeller

Investigation on the design of hydraulic high-speed punching press with a large press force and a long press stroke

Analysis and Simulations of Inertia Force in Ultra High Speed Stamping Machine

Analysis of the Cylinder Block Tilting Inertia Moment and Its Effect on the Performance of High-Speed Electro-Hydrostatic Actuator Pumps of Aircraft

Thermo-Mechanical Coupling Analysis of the Actuating Mechanism in a High Speed Press

Analysis of Imbalance Calculation Method in Dynamic Balancing Machinery

Optimal Design for Partial Inertia Force Cancellation in Ultra High Speed Pressing Machine

Effect of Piston-Slipper Assembly Mass Difference on the Cylinder Block Tilt in a High-Speed Electro-Hydrostatic Actuator Pump of Aircraft

Investigation on the Static Performance of Surface-Throttling Frictionless Pneumatic Cylinder Through Finite Element Method

Optimal Design Based on Method of Linearly Independent Vectors for Weight-Balancing Blocks in Ultra-High-Speed Pressing Machine

New Liquid Transfer Active Balancing System Using Compressed Air for Grinding Machine

Dynamic Modeling and Experiment of a New Type of Parallel Servo Press Considering Gravity Counterbalance

Investigation on a No Trial Weight Spray Online Dynamic Balancer

Review for Studying on Active Hybrid Auto-Balancer of Grinding Wheel and Motor Spindle

Static and Dynamic Deformation Analysis and Optimization of a Fine Blanking Press Frame

Control strategy and experiment research on liquid-transfer active balancing device by pneumatic means for grinding machines