Abstract:Vibrations in rotating machinery cause many problems such as excessive noise and the vibration transmission to the supporting structure. In addition, the vibration isolation of the machinery with a wide range of rotational speed is a vital requirement and different to realize in practical engineering. As one of the key components in rotating machinery, bearing is not only the major vibration excitation source, but also the main vibration transmission path. Therefore, the mechanical property of the bearing has a significant effect on the vibration of the rotating machinery. Compared with traditional mechanical bearing, the equivalent stiffness and damping of magnetic bearing can be changed by adjusting its control parameters. On this basis, a novel design strategy of parameters switched magnetic bearing and high static low dynamic stiffness (HSLDS) supports for the vibration isolation of rotating machinery is proposed in this article. The design changes the equivalent linear stiffness and damping of the magnetic bearing by adjusting the control parameters according to the rotor speed, which will improve the vibration isolation capability of magnetic bearing at different rotor speed. Meanwhile, to further reduce the vibration transmission, the rotating machinery was suspended by nonlinear isolator with high static low dynamic stiffness characteristic. As an example, a rotating machinery system consisting of a rigid rotor supported by parameters switched magnetic bearings and high static low dynamic stiffness supports is studied. In this model, the rotor is excited by the unbalance force with different rotational speed. The amplitude of force acted on the base and the maximum relative displacement between the journal and the bearing are used to judge the isolation performance. Simulation results show that the demonstrated the effectiveness of this design strategy and the force transmission is significantly reduced with a wide rotational speed range.

Vibration Isolation of Rotating Machinery by Control Parameters Switched Magnetic Bearing

Vibration Isolation of Rotating Machinery by Parameters Switched Magnetic Bearing and High Static Low Dynamic Stiffness Supports

The sliding variable structure control of mixed magnetic bearing system

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Vibration of Flexible Rotor Systems with Two-Degree-Of-Freedom Pid Controller of Active Magnetic Bearings

Two-Degree-of-Freedom Control for Active Magnetic Bearing Flywheel Rotor System Based on Inverse System Decoupling

Active Vibration Control of Rotor System by A Magneto-Rheological Fluid Damper

Matching Design of Active Magnetic Bearing and Elastic Support Vibration Isolator

A Vibration Mitigation Approach for Inverter-fed Permanent Magnet Motor Drive System

Study on the vibration attenuation capability of rotating machinery supported by active magnetic bearings

Decoupling Control for Active Magnetic Bearing High-speed Flywheel Rotor Based on Mode Separation and State Feedback

Active Control of Bearing Force Transmissibility for Active Magnetic Bearings-rigid Rotor Systems

Modal decoupling control for active magnetic bearing-supported flywheel rotor system

Synchronous Vibration Control for Magnetically Suspended Rotor System Using a Variable Angle Compensation Algorithm.

Rotor Vibration Control for Magnetic Suspended High-Speed Flywheel Energy Storage System with Inverse System Method and Extended 2-DOF PID Controller

Vibration Isolation Optimized Design of Magnetic Suspended Pump

Analysis of Stiffness and Damping Properties of Active Magnetic Bearing Using Cross Feedback Control

Rotor Periodic Vibration Suppression for Controlled Magnetic Levitation System

Application of an Active Magnetic Bearing and Bearingless Motor System to the Active Vibration Control of a Shaft

Dynamic Characteristics of Magnetorheological Fluid Lubricated Journal Bearing and Its Application to Rotor Vibration Control