Abstract:We have attempted to apply the computer-based finite element analysis (FEA) method to accurately measure the mechanical properties (e.g., hardness and elasticity) of a soft material by an indentation test. First, an axisymmetric model has been developed using commercially available FEA code ANSYS. The FEA model consisted of a thin Al-film resting on Si-substrate. A spherical indenter has been used to indent the Al-film, which traveled a predefined depth during the loading and unloading cycles. First, numerical simulations were conducted to get the force vs. displacement plot, which was later used to determine the modulus of elasticity and hardness of Al-film. The effects of substrate modulus and indentation depth were thoroughly investigated to determine the modulus and hardness of Al-film. The effect of friction, considered at the interface of indenter and Al-film, was found to offer minimum impact for relatively small indentation depth. The induced force on the Al-film by the indenter has been found to be higher with increasing indentation depth when friction was considered. However the contact stiffness, represented by the slope of the unloading curve, has been found almost the same with and without considering friction. The variation of substrate modulus has been found to be ineffective to capture the Al-film modulus for relatively small indentation depth. However for higher indentation depth, the substrate modulus has been found to offer profound effect to capture the film modulus. The hardness of the Al-film has also been found to be relatively unaffected with variation of substrate modulus. However, the hardness of the Al-film has been found to be higher with friction for relatively high indentation depth. Results obtained from this preliminary research are important to continue further investigation and to characterize the mechanical properties of other soft-materials, e.g., biofilms to minimize its detrimental effects and utilize its favorable aspects in industrial and biomedical applications.

Analysis of Size Effect in Nano-indentation Process of 3J21 Alloy Foil

Numerical studies on deformation and adhesion behaviour of substrate during nanoindentation

QUASICONTINUUM ANALYSIS OF INDENTER SIZE EFFECT IN NANOINDENTATION TESTS

Establishment of Simplified Constitutive Relationship for 3J21 Alloy and Its Nano-indentation Test

Size effect of nickel-based single crystal superalloy revealed by nanoindentation with low strain rates

In Situ Nanoindentation Mechanical Property of Films by Atomic Force Microscope

Measuring elastoplastic properties of thin films on an elastic substrate using sharp indentation

Determining mechanical properties of thin film in packaging structures by in-situ nanoindentation

Indentation Size Effect: A Study Via The Mechanism-Based Strain-Gradient Plasticity Theory

Effect of Surface Roughness on Nanoindentation Test of Thin Films

Experimental Tests and Numerical Simulation Studies on Nano-Indentation of Tin Film Deposited on N+-Implanted Aluminum

Nano-Indentation for Characterizing Mechanical Properties of Soft Materials

Multiscale Analysis of Size Effect of Surface Pit Defect in Nanoindentation

Impact of Micro-Indentation on Hardness and Indentation Depth of Ni-Cr Super Alloys

Quantitative Study of Roughness Effect in Nanoindentation on AISI316L Based on Simulation and Experiment

Size effect on the mechanical responses of aluminum nanoparticles under indentation: A molecular dynamics study

The role of rough surface in the size-dependent behavior upon nano-indentation

Comparison of nano-indentation hardness to microhardness

THEORETICAL METHODS ON NANOINDENTATION

Finite element analysis of the critical ratio of coating thickness to indentation depth for coating property measurements by nanoindentation