Abstract:In order to improve the complex numerical calculation process for wet coating of pole piece, a three-dimensional numerical model of heat-mass transfer characteristics is established between hot wind and wet coating based on multi-field coupling theory of porous media and meshless parallel method, and its reliability is verified through literature data. Meanwhile, the difference calculation method and evaluation process are proposed for heat-mass transfer characteristics to solve this numerical model. The results show that the maximum errors are less than 14.7 % for this model. In addition, a scale modeling method is proposed to improve computational efficiency based on similarity theory. Meanwhile, the influences of different scale factors on temperature and humidity parameters are analyzed for wet coating. The results show that this method is accurate and reliable because the determination coefficient R 2 of all parameters is more than 0.99. Meanwhile, compared with the calculation time of original model, the calculation efficiency increases by 44.6 % for the model with scale factor selected as 800. Finally, the variation and distribution of internal parameters are analyzed for wet coating during pore emptying process based on above simulation method. The results show that the variation trends of liquid film thickness, pore emptying rate, water saturation, gas saturation and effective gas diffusion coefficient are corresponding with the accelerated, uniform and decelerated drying processes of porous media. Meanwhile, the location of four-corner edges for wet coating is the weak link in heat-mass transfer process. Therefore, the heat-mass transfer characteristics for wet coating can be improved by increasing its initial thickness or adjust reasonable drying position in engineering.

Numerical Simulation and Test Study on Particulate Materials Mass Transfer

Heat Transfer of Batch Simulating Continuous Fluidized Bed with Wet Particles

Numerical Simulations of Flow Structure and Heat Transfer in a Central Jet Bubbling Fluidized Bed

NUMERICAL SIMULATION FOR DRYING PROCESS OF GAS FLOW CONTAINING HUMID COAL ASH PARTICLES

Mass-Transfer Simulation Software Study of Sliced Porous Production During Convection Drying Process

Numerical Simulation of Heat and Mass Transfer in Sludge Low-Temperature Drying Process

Modeling Simultaneous Heat and Mass Transfer for Microwave Drying on Apple

Effect of heat and mass transfer coefficients on force convective drying of porous media

Mass and Heat Transport Models for Analysis of the Drying Process in Porous Media: A Review and Numerical Implementation

CFD-DEM investigation of the gas-solid flow characteristics in a fluidized bed dryer

Numerical Simulation Of Heat And Mass Transfer In Air-Water Direct Contact Using Computational Fluid Dynamics

Numerical and experimental investigation of convective drying in unsaturated porous media with bound water

Numerical simulation of falling film evaporation of binary mixture

Simulation method of heat-mass transfer between hot wind and wet coating in the manufacturing process of pole piece

Numerical and experimental analysis on air/water direct contact heat and mass transfer in the humidifier

Numerical simulation of natural convective heat and mass transfer in porous media

Numerical simulation of the fine kinetics of dust reduction using high-speed aerosols

Heat and Mass Transfer in Unsaturated Porous Cake with Heated Walls

Numerical Investigation on Droplet Collision Phenomena in Moisture Separators Using Population Balance Model under Lagrangian Framework

Mathematical model and numerical investigation of the influence of spray drying parameters on granule sizes of mold powder

Numerical Analysis of Heat and Mass Transfer During Pyrolysis of Coal Particle