Abstract:This article focuses on evaporative falling film heat transfer through numerical simulations. A two-dimensional symmetric liquid film flowing outside a single horizontal tube was simulated using the open-source CFD software OpenFOAM. The Tanasawa model was employed to consider mass transfer at the liquid–vapour interface, and the isoAdvector VOF method was used for interface tracking. The simulations explored the impact of film flow rate, tube surface heat flux, and tube diameter on the liquid film thickness and surface heat transfer coefficient. Additionally, the critical heat flux and operational limits were considered. The results demonstrate the accurate reproduction of evaporative falling film heat transfer performance by the present model. The film thickness exhibits a similar profile to adiabatic and sensible falling film heat transfer but provides smaller values. Similarly, the evaporative heat transfer coefficient exhibits significantly higher values and a gentle peripheral variation. The influence of heat flux on evaporative falling film heat transfer is contingent on the film flow rate; it can either enhance or weaken the process. Notably, a larger tube diameter negatively affects heat transfer, suppressing the impact of heat flux, and also increases the risk of liquid film dryout. For a given film flow rate, the average heat transfer coefficient increases initially, reaches a maximum value, and then decreases as the wall heat flux is increased. The peak heat flux, termed critical heat flux, increases with film flow rate but decreases with tube diameter. An operational limit exists where the heat flux is lower than the critical heat flux and the film flow rate is higher than the critical film flow rate; under these conditions, evaporative falling film heat transfer operates in a fully wetting status.

Numerical simulation of falling film evaporation of binary mixture

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

Numerical simulation for character of fluid flow through packed bed

Numerical Simulation On Heat Transfer Of Falling Film Flow Along A Vertical Wall

Modelling of evaporative falling-film heat transfer over a horizontal tube

Establishment of the falling film evaporation model and correlation of the overall heat transfer coefficient

Numerical simulation of oscillatory falling liquid film flows

Thin liquid film flow and heat transfer under spray impingement

Numerical analysis on flow and heat transfer of a tube bundle in a horizontal-tube falling film evaporator

Numerical simulation and modeling of the heat and mass transfer in a grooved flat falling film evaporator

Computational study of falling film evaporation in vertical channel

The Effect of Interfacial Evaporation on Heat and Mass Transfer of Falling Liquid Film

Experimental Study and Numerical Simulation on Falling Film Thickness Outside a Horizontal Tube

Effect of evaporation rate for the heat and mass transfer of the laminar liquid falling film in still air

Numerical Simulations of Laminar Film Condensation of H2O/Air or H2O/CO2 on a Vertical Plate

Numerical investigation on the longitudinal distribution characteristics of falling film flow outside a vertical tube

A Numerical Model for Simulating the Droplet Flow and Evaporation

Numerical investigation of effective parameters of falling film evaporation in a vertical‐tube evaporator

Condensation and evaporation of binary droplets with internal mass transfer

Boiling and evaporation model for liquid-gas flows: A sharp and conservative method based on the geometrical VOF approach

Numerical Investigation on R32 Flow Boiling in Smooth Mini-Tube