Abstract:Boring trepanning association (BTA) deep hole drilling is one of the most important manufacturing techniques to produce a large length-to-diameter ratio hole for industrial applications. In addressing the challenge of excessive surface damage, inefficiency and poor indexing in BTA deep hole drilling, for which there are limited studies reported. The functional behaviour of deep hole machining and the correlation between the machined surface quality, subsurface layer deformation and the machining conditions are investigated in this paper, together with the drilling mechanism. Various parameter combinations are used to produce different samples on which surface roughness and microstructures are studied. Metallurgical characterization is performed on the subsurface regions, followed by qualitative and quantitative mechanical nanohardness investigations. Electron microscopic analysis reveals various surface features such as grooves and plateaus, folding, material flaking that are exclusive to deep hole drilling. It has been found that improved surface integrity in BTA drilling relies on a trade-off among feedrates and speeds. Although considered sample dependent, combination of a feedrate of 28 mm min(-1) and a speed of 630 r min(-1) can produce nearly excellent surface integrity. Grain structure observations over the subsurface reveal three different layered zones including an ultrafine grain structure layer, a transitional grain structure layer and a substrate material layer. A significantly hardened (56% increase) surface layer on cutting-and-burnishing region comparing with the solely cutting region is detected. The subsurface grain features are induced by repeated thermo-mechanical functioning that causes grain refinement and thus materials hardening. The different surface integrities are the result of comprehensive functions of the machining parameters and combined drilling mechanism.

The Influence of Plateau Honing Process Parameters on Cylinder Bore Surface Roughness

A Multiscale Evaluation of the Surface Integrity in Boring Trepanning Association Deep Hole Drilling

Wear Resistance Analysis of Plateau Honing Surface for Ceramics Mg-PSZ

Mutual influence of plateau roughness and groove texture of honed surface on frictional performance of piston ring–liner system

Effect and Mechanism of Roughness on the Performance of a Five-Stage Axial Flow Compressor

Experimental Research on the Effect of Grinding Parameters on Ceramic Machined Surface Roughness

Investigation on formation mechanism of surface texture and modeling of surface roughness with internal gear power honing

Effect of surface roughness on stress concentration factor of machined surface and cutting parameter optimization in boring of Al-Si piston alloy

Numerical analysis and experimental validation of surface roughness and morphology in honing of Inconel 718 nickel-based superalloy

Effect of Surface Texture on Wear Reduction of the Tilting Cylinder and the Valve Plate for a High-Speed Electro-Hydrostatic Actuator Pump

Experimental Study on the Influence of the Rotating Cylinder Block and Pistons on Churning Losses in Axial Piston Pumps

Effects of the Piston Skirt's Surface Structure on Coating Quality and Friction Functions

Simulation to Microtopography Formation of CBN Active Abrasives on a Honing Wheel Surface

The Influence of Roughness Distribution Characteristic on the Lubrication Performance of Textured Cylinder Liners

Simulation and experimental investigation on low wear rate surface contour of piston/cylinder pair in an axial piston pump

Optimization of process parameters for polishing aero-engine blade with abrasive cloth wheel considering spindle vibration and polished roughness

Free-floating dynamic material removal mechanism of the honing process

Experimental Study for Optimizing Superfinishing Process Parameters of High-Quality Alloy Bearing Steel

Research on the Profile Design of Surface Texture in Piston Ring of Internal Combustion Engine

Process-surface morphology-tribological property relationships for H62 brass employing various manufacturing approaches

Tribological Design of the Running-in Process