Abstract:This paper presents a numerical approach to simulate sliding friction between engineering surfaces with 3D roughness in point contacts. The numerical approach is developed on the basis of the deterministic solutions of mixed lubrication, which is able to predict the locations where the asperity contacts occur, and the pressure distribution over both lubrication and contact areas. If the friction coefficients over the contacting asperities have been determined, total friction force between the surfaces can be calculated by summing up the two components, i.e., the boundary friction contributed by contacting asperities and the shear stress in hydrodynamic regions. The fi-ictions from asperity contact were determined in terms of a limiting shear stress or shearstrength of boundary, films while the fluid shear stress in the lubrication areas was calculated using different rheology models for the lubricant, in order to find which one would be more reliable in predicting fluid tractions. The simulations covered the entire lubrication, regime, including full-film Elastohydrodynamic Lubrication (EHL), mixed lubrication, and boundary lubrication. The results, when being plotted as a function of sliding velocity, give a Stribeck-type friction curve. This provides an opportunity to study friction change during the transition of lubrication conditions and to compare friction performance oil different rough surpces, which is of great value in engineering practice. Experiments were conducted on a commercial test device-universal material tester (UMT) to measure friction at a fixed load but different sliding velocities in reciprocal or rotary motions. The results also give rise to the Stribeck friction curvesfor different rough surfaces, which are to be compared with the results from simulations. The samples were prepared with typical machined surfaces in different roughness heights and textures, and in point contacts with steel ball. Results show that there is a general agreement between the experiments and simulations. It is found that surface features, such as roughness amplitude and patterns, may have a significant effect on the critical speed of transition firom hydrodynamic to mixed lubrication. It? the regime of mixed lubrication, rougher samples would give rise to a higherfiriction if the operation conditions are the same.

Analysis of the Velocity in Z Direction in Sliding Model of Double Rough Solids

2D Numerical Model for Studying Frictional Sliding

Sliding State Analysis of Fractal Rough Interface Based on the Finite Element Method

Shear characteristics of interface based on subloading-friction model

Micro Sliding Friction Model Considering Periodic Variation Stress Distribution of Contact Surface and Experimental Verification

Tribological mechanism of micro/meso/macroscopic textured surfaces under different normal forces, relative velocities, and sliding directions

Mechanism Analysis and Improved Model for Stick-Slip Friction Behavior Considering Stress Distribution Variation of Interface

Simulation of Sliding Wear in Mixed Lubrication

Simulations And Measurements Of Sliding Friction Between Rough Surfaces In Point Contacts: From Ehl To Boundary Lubrication

Load-velocity-temperature relationship in frictional response of microscopic contacts

A Bi-Gaussian Acoustic Emission Model for Sliding Friction

Frictional heat accumulation at cyclically rolling-sliding contacts with consideration to time-dependent contact pressure

Modeling of Frictional Stick-Slip of Contact Interfaces Considering Normal Fractal Contact

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Temperature Rise in Frictional Sliding Contact of Elastic–Plastic Solids with Fractal Surface

Thermomechanical modeling and transient analysis of sliding contacts between an elastic–plastic asperity and a rigid isothermal flat

Investigation on dynamics performance of multibody system with rough surface

A computer model for sliding friction in lubricated-point contacts

Prediction of Sliding Friction Force of Rough Surfaces in Lubricated Point Contacts

Modeling and Measurement on the Sliding Behavior of Microgrooved Surfaces.

A Simulation Method of Thermo-Mechanical and Tribological Coupled Analysis in Dry Sliding Systems