Abstract:Because of the higher requirements for vehicle comfort and people’s increasing ecological consciousness, research on the interior noise in a vehicle has received wide concern, among which structure-borne noise is hard to diagnose and control. To solve the problem, the transfer path analysis method of powertrain structure-borne noise has been systematically analysed. By introduction of the powertrain source–path–receiver model, this method enables us to estimate and study the vibro-acoustic transfer functions and their operational forces. Since structure-borne noise is composed of multiple paths, the aim of this paper is to discuss different synthesis methods for this noise. On the basis of previous discussion, the transfer path analysis test of a certain vehicle is carried out, and the transfer function and operational data at idle and second-gear wide-open throttle are obtained. The test data are processed and an acoustic contribution analysis of the target is performed using LMS software. The results of analysis show that the right-hand side mount represents the main contribution path. Then the match principle of the bracket dynamic stiffness of the powertrain isolation system is proposed. On the basis of the transfer path analysis results and the above principle, the bracket on the body side of the right-hand side mount is improved by combination of the experimental transfer path analysis and the finite element method. The test results show that the A-weighted sound pressure level of the interior noise at idle and second-gear wide-open throttle are reduced by 2.9 dB(A) and 4 dB(A) respectively after improvement. Also there is no obvious booming noise at second-gear wide-open throttle. It is expected that this paper can help automotive noise, vibration and harshness engineers to perform trouble shooting and sound design.

Study and Analysis of the Automotive Interior Noise Caused by Medium and High Frequency Vibration

Research on Control of Car Interior Noise due to Engine Vibration

Investigation on Technology of Automobile Vibration and Noise Reduction Based on Body-In-White Structure

Impact Mechanism of Drivetrain Torsional Vibration on the Car's Low Frequency Interior NVH Performance

Interior Structure-Borne Noise Reduction by Controlling the Automotive Body Panel Vibration

Study on Transfer Path Analysis Method of Automobile Interior Noise

Analysis and Control of the Interior Noise and Vibration of a Mini-vehicle

Interior Noise Analysis of a Non-load Type Body SUV

Experimental analysis for the interior noise characteristics of the fuel cell car

Analysis of Noise and Vibration for a New Pure Electrical Vehicle

Experimental Analysis and Control to the Rear Interior Noise of the Fuel Cell Vehicle

Simulation and Analysis of Vehicle Inner Noise Excited by Roughness Based on Acoustic Transfer Vector Method

Identification of dominant interior noise sources in micro commercial vehicle based on sound quality analyzing

Vehicle Interior High Frequency Noise under Engine Acoustic Excitation

Transfer Path Analysis and Control of Vehicle Structure-Borne Noise Induced by the Powertrain

Study on coupling between body structure vibration and interior noise

Research and Simulation Analysis of Fuel Cell Vehicle Interior Noise

Noise and Vibration Source Identification in Passenger Car

Application of measurement technology of sound intensity in noise source identification of automotive interior noise

Study on Interior Noise Control of Vehicles with Damping Structure

Study on Automotive Interior Structural Noise Excited by Engines