Abstract:The cylinder gas film seal between dual-rotor reverse shafts is a new method for sealing aircraft engines that has excellent developmental prospects. We propose a novel method for determining if the sealing ring is fully fluid-lubricated using the average Reynolds equation. Considering surface roughness and centrifugal expansion, we calculated the dynamic pressure, gas film force and friction power consumption with and without inlet pressure differences for each of the four rotation modes. The gas film’s dynamic pressure effects were weakest when the dual rotors rotated in a reverse direction (Mode 3), with or without differences in inlet pressure, since solid contact is most likely to occur under counter-rotation. When the dual rotors were in counter-rotation with an inlet differential pressure of 80 kPa and fixed inner and outer rotor speeds (e.g., 3000 rpm), we calculated the minimum sealing ring film thickness, leakage rate, friction power consumption and gas film force. Changes in outer rotor speed greatly influenced the minimum film thickness and the sealing ring’s performance. Meanwhile, changes in the inner rotor speed had little influence on the minimum film thickness and sealing ring’s lubrication performance. When the speed difference was fixed and the sealing ring was fully fluid-lubricated, lubrication performance changes were mainly affected by changes in centrifugal expansion caused by the outer rotor speed. Given a fixed rotor speed and under dual-rotor counter-rotation, we calculated the effects of inlet differential pressure changes on minimum gas film thickness, leakage rate, friction power consumption, gas film force and other sealing performance variables. Leakage rate and the friction power consumption increase as inlet differential pressure increases. Our results provide a theoretical reference for avoiding solid contact of the cylinder seal between dual-rotor reverse shafts.

Research and Analysis on the Radial Clearance Leakage for Translational Rotary Compres-sors

Performance Analysis of the Cylinder Gas Film Seal between Dual-Rotor Reverse Shafts Considering Lubrication and Centrifugal Expansion Effects

Research on Leakage of Translational Rotary Compressor

Study on Leakage via the Radial Clearance in a Double Vane Ellipse Rotor Compressor

Study on leakage via the radial clearance in a novel synchronal rotary refrigeration compressor

Numerical analysis of the transient leakage flow in axial clearance of a scroll refrigeration compressor

The Clearance Leakage Models of the Rolling Piston Compressors

A Mathematical Model for Internal Leakage in a Rotary Compressor

Investigation Into The Performance Of The Vl Seal Based On The 3d Model

Research on Leakage in Synchronal Rotary Air Compressor

Numerical Research on the Hydrodynamic Effect on the Leakage of Two-Phase Refrigerant-Oil Mixture in the Flank Gaps of Compressors

Numerical Analysis on Influence of Radial Clearance on Leakage Flow Characteristics of Brush Seal

Theoretical study and experimental verification of the leakage losses of R410A in the swing compressor with no valves

Investigation of the Compression and Expansion Process for Reciprocating Compressor

Investigation of the leakage in the flow distribution pair of radial piston hydraulic motors through CFD analysis and experiments

Analysis of the leakage in a water-lubricated twin-screw air compressor

Theoretical Calculation of Leakage in Micro Scroll Compressors

Modeling and Experimental Investigation on the Internal Leakage in a CO2 Rotary Vane Expander

Analysis, modeling and simulations of an innovative sliding vane rotary compressor with a rotating cylinder

New Analytical Leakage Models for Tribological Interfaces in Axial Piston Pumps

Experimental Study on Effect of Clearance Volume on Performance of Rotary Compressor