Abstract:The transient flow model of a scroll refrigeration compressor which included axial clearance was established in the paper using PUMPLINX based on the computational fluid dynamics and the dynamic grid methodology. According to the actual size in the physical compressor, the flank and the axial clearances were set equal to 0.030 mm and 0.015 mm, respectively. As the fluid domain of the axial clearance was too small to generate enough layers of grids in PUMPLINX, it was first magnified 100 times to generate grids of high quality, and then the fluid domain and grids were recompressed to the original size. The simulation results were verified experimentally. The influence of the radial leakage on the downstream flow field was investigated. Moreover, the characteristics of radial and tangential leakage flows were analyzed. It was concluded that the predictions of the compressor performance, except the discharge temperature, are improved after the axial clearance was included in the model. The radial leakage is dominant while a portion of involute leakage flow exists near the flank clearance. The influence of radial leakage on the downstream temperature is lower than that of the tangential leakage in flank clearance. The tangential leakage flow is turbulent basically while the radial leakage flow is laminar. The tangential leakage is severer at the beginning of the discharge process, and the radial leakage is more remarkable at the end of the compression process. When the pressure ratio across the leakage path is higher than the critical pressure ratio, the tangential leakage flow becomes supersonic for the converging–diverging clearance structure, while the radial leakage flow remains subsonic due to the larger flow losses. The results obtained through this research could be applied to modify the current leakage models and optimize the clearances of scroll compressors.

Research on Leakage of Translational Rotary Compressor

Research and Analysis on the Radial Clearance Leakage for Translational Rotary Compres-sors

Research on Leakage in Synchronal Rotary Air Compressor

Study on leakage via the radial clearance in a novel synchronal rotary refrigeration compressor

Study on Leakage via the Radial Clearance in a Double Vane Ellipse Rotor Compressor

Modeling and Experimental Investigation on the Internal Leakage in a CO2 Rotary Vane Expander

A Mathematical Model for Internal Leakage in a Rotary Compressor

The Clearance Leakage Models of the Rolling Piston Compressors

Numerical analysis of the transient leakage flow in axial clearance of a scroll refrigeration compressor

Theoretical study and experimental verification of the leakage losses of R410A in the swing compressor with no valves

Numerical Research on the Hydrodynamic Effect on the Leakage of Two-Phase Refrigerant-Oil Mixture in the Flank Gaps of Compressors

Theoretical Calculation of Leakage in Micro Scroll Compressors

Analysis, modeling and simulations of an innovative sliding vane rotary compressor with a rotating cylinder

Discussion on leaking characters in meso-scroll compressor

Investigation of the Compression and Expansion Process for Reciprocating Compressor

Study of a Rotary Vane Expander for the Transcritical CO 2 Cycle—Part II: Theoretical Modeling

Investigation of Gas Compression Process for Reciprocating Compressor

Leakage Loss Study of a Synchronal Rotary Multiphase Pump with a Full Range of Inlet Gas Volume Fractions

Kinetic characteristic for a synchronal rotary compressor

Analysis of 3D Transient Flow in a High-Speed Scroll Refrigeration Compressor

Analysis of the leakage in a water-lubricated twin-screw air compressor