Abstract:Unsteady numerical studies were conducted on the effects of combustor exit total pressure non uniformity and hot streak (HS) on the aero-thermal characteristics of a high-pressure (HP) turbine stage. Firstly, four total pressure profiles including uniform, turbulent boundary layer, realistic engine combustor exit and radial reverse total pressure (higher total pressure near the endwall) were applied to reveal the vortex structures and heat transfer characteristics of the turbine. Then the four total pressure profiles coupled with inlet HS were specified to study the HS migration mechanisms. The results indicated that the turbulent boundary layer total pressure intensifies the passage vortices (PVs) while the higher total pressure near the endwall induces counter rotating vortices (CRVs), in both the stator and rotor passages. The heat transfer on the vane and blade surfaces was affected by the vortices and the extent of the impact directly depends on the intensity of the vortices, which is determined by the gradient of the total pressure. The heat transfer coefficients (HTCs) on the vane and blade pressure surface are increased by 104% and 20-30%, respectively, due to the CRV effects. The increase of tip leakage flow for the higher total pressure near the tip enhances the tip pressure side HTC by 4% comparing with the uniform case. The PVs and CRVs from the stator passage persistently exist in the rotor passage near the suction side endwall while have negligible influence on the rotor heat transfer. The migration paths of the hot streak are significantly affected by the PVs and CRVs in the stator passage, and the rotor blade surface temperature is dominated by both of the redistribution of HS in the vane passage and the vortices in the rotor passage. The PVs extend the HS radial migration and increase the vane and blade surface temperature. While the CRVs circulate the hot fluid away from the vane surface and increase the HS attenuation, thus decrease the vane and blade surface temperature significantly. The total pressure non-uniformity also decreases the turbine adiabatic efficiency by 0.6% at uniform inlet temperature condition. (C) 2016 Elsevier Ltd. All rights reserved.

Numerical Study on Meridional Passage Contour of Casing in an Inter-turbine Duct

Effects of diffused meridional passage contour on loss

Numerical Study on Aerodynamic Characteristics of a Large Radius Change to Length Ratio Intermediate Duct

Numerical Study on Meridional Line Modification Design of the Exhaust Hood Inner Guiding Annulus

Numerical Investigation of the Effects of Rising Angle on Intermediate Turbine Duct and Nearby Turbines

THE EFFECTS OF CASING PROFILE ON THE AERODYNAMICS OF INTEGRATED INTERMEDIATE TURBINE DUCTS

Design performance evaluation and vortex structure investigation of different S-shaped intermediate turbine ducts

Performance Analysis of Non-Symmetric Exhaust Duct in A MW-Level Gas Turbine

Numerical Study on the Aerodynamic Performance of Three-stage Turbine Inner Flow Field with Cooling Air Mixing

Numerical Simulation of Inner Flow in Equal-pitch Inducer

Numerical Research of the Inner Flow Field of an Intermediate Pressure Steam Turbine's Inlet Chamber

Numerical Study on the Influence of Inlet Turbulence Intensity on Turbine Cascades

Numerical Study on Separation Flows of a Compressor Transition Duct

Influence of Reynolds Number on the Unsteady Aerodynamics of Integrated Aggressive Intermediate Turbine Duct

Numerical research on the aerodynamic performance of inlet volute duct for a heavy-duty gas turbine

Numerical Analysis on Effects of Inlet Pressure and Temperature Non-Uniformities on Aero-Thermal Performance of a HP Turbine

Effects of Inlet Total Pressure Non-Uniformities on Aero-Thermal Performance of Gas Turbine Endwalls

Numerical Study on Nozzle Exit Flow Angle for Radial Turbine

Modification Design of Inlet Duct for a Helium Circulator

Internal flow mechanism of an aggressive compressor transition duct

Numerical Investigation on Flow Characteristics in Steam Turbine Low Pressure Cylinder and LPEH under Different Volume Flow Rate Conditions