Abstract:High-precision and fault-tolerant six-dimensional force/torque sensor is one of the core components of intelligent robots for force feedback perception. This paper is aiming at the fault-tolerant measurement mechanism research on piezoelectric six-dimensional force/torque sensors with four-point support structure. Based on principle of leverage and deformation consistent, the fault-tolerant measurement mechanism of the pre-tightened four-point supported piezoelectric six-dimensional force/torque sensor is revealed. The mapping mathematical models of spatial six-dimensional force and four-fulcrum quartz crystal group detection signal for the sensor without signal fault and with signal fault are constructed respectively. The static calibration system of the sensor is built to realize the fault-tolerant static calibration experiment of the four-point supported piezoelectric six-dimensional force/torque sensor prototype under unidirectional loading without signal fault and with signal fault. In order to improve the measurement precision of six-dimensional force/torque sensor for robot, a decoupling method based on Genetic Algorithm to optimize Back Propagation algorithm (GABP) for piezoelectric six-dimensional force/torque sensor is adopted to solve the nonlinear cross coupling problem of multiple-input and multiple-output. Through Maltlab software, the test data are analyzed and calculated, and the percentage coupling error matrix of the sensor is calculated. The percentage coupling error is different when the sensor is fault-free and the fault-free measurement model is different. When the sensor is fault-free, the linearity of the sensor is the best and the maximum coupling error is less than 1.5%. When the sensor has any branch fault, the overall performance of the sensor is relatively weakened and the maximum coupling error increases. When the sensor has two branch faults, the linearity of the sensor is the worst. It cannot satisfy the requirement of accurate measurement. The research content is of great significance to the development and practicality of fault-tolerant multi-point supported piezoelectric six-dimensional force/torque sensor.

Study on Test Precision of Piezoelectric Force Sensor Under Load Deviation Calibration

A Three-dimension High-Precision and Non-contact Dynamic Angular Displacement Measurement System based on Heterodyne Interference

Development of a Novel Strategy Based on In-Process Compensation of Charge Leakage for Static Force Measurement by Piezoelectric Force Sensors

A Differential Strategy for Measurement of a Static Force in a Single-Point Diamond Cutting by a Force-Controlled Fast Tool Servo

Absolute quasi-static calibration method of piezoelectric high-pressure sensor based on force sensor

Fault-tolerant measurement mechanism research on pre-tightened four-point supported piezoelectric six-dimensional force/torque sensor

A novel load ratio calculation method for calibrating force

Precision tilting platform used for static calibration of accelerometers

Research on dynamic calibration and compensation method of strain-gauge type force sensor

Identification of Static Loading Conditions Using Piezoelectric Sensor Arrays

Study on the Influence of Structural Parameters of Multi-Dimensional Force Sensor on Test Sensitivity

Analysis and research of piezoelectric dynamic weighing sensor

Calibration Of Non-Linearity Of Piezo Elements And Image Distortion In Atomic Force Microscope

Accurate Nonlinearity and Temperature Compensation Method for Piezoresistive Pressure Sensors Based on Data Generation.

The Device for Calibration Based on the Six-freedom of Generalized Force

A Research on Calibration of Low-Precision Mems Inertial Sensors

Ground Force Precision Calibration Method for Customized Piezoresistance Sensing Flexible Force Measurement Mat

Research on a Precision Calibration Model of a Flexible Strain Sensor Based on a Variable Section Cantilever Beam

Calibration of piezoelectric positioning actuators using a reference voltage-to-displacement transducer based on quartz tuning forks

Research for piezoresistive pressure sensors: Methods to reduce the influence of processing deviation on sensitivity and improve product consistency

Research on Automotive Dynamic Weighing Method Based on Piezoelectric Sensor