Abstract:Ultrasonic guided wave testing (UGWT) is used in rapid screening to detect, locate and classify corrosion defects. This non-destructive testing technique can perform wide-range inspection from a single point, thus reducing the time and effort required for NDT. However, the mode conversion phenomena and the dispersive nature of the guided waves make corrosion detection difficult. Hence, the parametric studies on the response signals of a T (0, 1) wave from pipe defects were presented in this paper. Firstly, a mathematical model of 6-inch schedule 40 pipes was developed. The corrosion profile of various geometries was then constructed on the outer surface of the pipeline by varying the circumferential length and depth. The numerical study was performed to analyse the characteristics of the response signals when a torsional guided wave impinges on the corroded pipelines. A five-cycle Hanning tone-burst signal with a central frequency of 30k Hz was used throughout the study. The results demonstrated that mode conversion to a flexural mode F (1, m) occurs when the stimulated T (0, 1) strikes non-symmetric defects. Nonetheless, as the circumferential extent of the corrosion increased, the response signals tended to behave symmetrically, and there was less mode conversion detected. Thus, the presence of flexural mode F (1, m) can be used as the criteria to distinguish symmetric and asymmetric faults. In addition, the results demonstrated that the reflection coefficients increase monotonically with the defect's depth due to the increases in the estimated cross-sectional area loss (ECL). As a result, a more significant proportion of the transmission wave was reflected. These findings serve as guidelines for on-site inspections. With the known speed of guided wave propagation, it is possible to precisely forecast the position of faults.

Experimental Investigation of Underwater Pipeline Inspection Using Ultrasonic Guided Waves

Implementing Ultrasonic Guided Wave Mode Control in Hollow Cylinders

Evaluation of Pipe Axial Defeat Through the Use of Ultrasonic Guided Wave and Matching Pursuit

The analysis of mechanism for generating and detecting torsional guided wave

Long-distance structural health monitoring of buried pipes using pitch-catch T(0,1) wave piezoelectric ring array transducers

Circumferential SH Wave Piezoelectric Transducer System for Monitoring Corrosion-Like Defect in Large-Diameter Pipes

Ultrasonic guided wave testing on pipeline corrosion detection using torsional T(0,1) guided waves

Study on simulation of non-destructive testing for pipeline defects by ultrasonic guided waves

Non-destructive Evaluation of Spiral-welded Pipes Using Flexural Guided Waves

Method to submarine pipe status inspection in strong tide region: submarine pipe status inspection in Hangzhou Bay

Ultrasonic Guided Wave Testing Trials for Pipes

Experimental Investigation of Deformation Damage Detection in Pipes Using Ultrasonic Guided Waves

Theoretical and Experimental Studies of Longitudinal Guided Wave Generation in Hollow Cylinders by Multielement Transducers

Development of a 16-Channel Broadband Piezoelectric Micro Ultrasonic Transducer Array Probe for Pipeline Butt-Welded Defect Detection

Study of an ultrasonic inspection system by a long waveguide surrounding a pipe in the circumferential direction as an ultrasonic source

Design and experimental study of electromagnetic ultrasonic single-mode guided wave transducer for small-diameter stainless steel tubes

Development of a Helical Lamb Wave Electromagnetic Acoustic Transducer for Pipeline Inspection

Detection and Identification of Dents in Pipelines Using Guided Waves

Simulation of Detection Pipeline Cracks by Longitudinal Ultrasonic Guided Waves

Mode Conversion Behavior of Guided Wave in A Pipe Inspection System Based on A Long Waveguide

Numerical Simulation of Pipeline Defect Detection Based on Piezoelectric Ultrasonic Guided Wave