Abstract:<p>Dents have been identified as among the most common deformation defects in oil and gas pipelines. In this study, the multidimensional mechanical responses, springback, and rerounding behaviors of dents as well as the interaction of multiple dents on pipelines and their effect on pipe integrity were investigated through the three-dimensional finite element method and full-scale burst tests. The burst test demonstrates that a plain dent has a minimal effect on the pipeline burst pressure, and the burst failure position is not located in the dented area. Generally, when a dented pipeline that is subjected to monotonically increasing internal pressure bursts, the dent does not fully reround, and a convex protuberance forms in the axial shoulders on both sides of the dent. During pressurization, the maximum equivalent plastic strain in the dented pipe always occurs on the inner surface near the dent center in which no necking is found in the radial direction of the wall thickness. However, a larger equivalent stress is observed around the edge of the dent center, whereas the stress at the center is relatively small, resulting in the formation of a plastic hinge in the dented area. If internal pressure fluctuations occur, this can easily lead to fatigue failure. Finally, the interaction among multiple longitudinally aligned dents was investigated, and the critical spacing affecting the integrity of the pipeline was determined. The investigation reveals that when the dent spacing exceeds the pipe diameter, the interaction between two dents may be ignored, and the dent effect on the pipe integrity may be separately evaluated. However, if the dent spacing is less than 0.5 times the pipe diameter, then the dents must be treated as a combined dent. Further, if the spacing is 0.5–1.0 times the pipe diameter, then dent interaction must be considered.</p>

Detection and Identification of Dents in Pipelines Using Guided Waves

The Reflection of Guided Waves from Simple Dents in Pipes.

Evaluation of Pipe Axial Defeat Through the Use of Ultrasonic Guided Wave and Matching Pursuit

In-Line Nondestructive Inspection of Mechanical Dents on Pipelines With Guided Shear Horizontal Wave Electromagnetic Acoustic Transducers

Experimental Investigation of Deformation Damage Detection in Pipes Using Ultrasonic Guided Waves

Damage Determination of Pipelines Based on Variation of Vibrating Frequencies

Non-destructive Evaluation of Pipes by Microwave Techniques and Artificial Neural Networks

Noncontact Laser Inspection Based on a PSD for the Inner Surface of Minidiameter Pipes.

Damage Identification of Pipeline Based on Ultrasonic Guided Wave and Wavelet Denoising

Bend Detection of Pipe Using Guided Waves

Multi-dimensional mechanical response of multiple longitudinally aligned dents on pipelines and its effect on pipe integrity

Non-destructive Evaluation of Spiral-welded Pipes Using Flexural Guided Waves

Study on simulation of non-destructive testing for pipeline defects by ultrasonic guided waves

Application of Microwaves for Nondestructive and High-Efficiency Detection of Wall Thinning Locations in a Long-Distance Metal Pipe

Guided wave-based bend detection in pipes using in-plane shear piezoelectric wafers

Fluid Pipe Nondestructive Testing Based on Ultrasonic Guided Waves

Evaluation of Cross-Sectional Deformation in Pipes Using Reflection of Fundamental Guided-Waves

Analysis of ductile damage changes of pipelines with unconstrained dents in rebound process

Deconvolution Imaging of Weak Reflective Pipe Defects Using Guided-Wave Signals Captured by a Scanning Receiver

Simulation of Detection Pipeline Cracks by Longitudinal Ultrasonic Guided Waves

Accurate Modeling and Safety Evaluation of Dented Pipeline with Internal Pressure Based on Reverse Modeling Technique