Abstract:Gate valves, which are widely applied in pneumatic conveying systems, are vulnerable to erosion by particles. It is thus important to investigate the erosion in gate valves from the perspective of fluid analysis, and then to predict and improve their lifetimes. The effects of valve geometry and gas-solid flow conditions on valve erosion are investigated. Since a gate valve usually operates fully open to let fluid pass through, the geometry is simplified as a cavity. As gate valves are always placed horizontally in industrial situations, investigated cavities are placed horizontally, and the erosion damage to the bottom half of the aft wall (surface T), which is most likely to be eroded, is studied. A computational fluid dynamics (CFD) based two-way Eulerian-Lagrangian procedue is used to predict the erosion severity. The simulation procedure is validated by comparing the CFD results with those obtained from experiments of a pipe and an elbow, and also with the erosion region of a damaged valve. For convenience, the total erosion ratio, defined as the ratio of the mass eroded on a particular surface to the total particle mass passing through the pipe inlet during the same time, is introduced. The results show that the total erosion ratio of surface T is largely independent of the mass flux ratio, pipe diameter and cavity depth. Meanwhile, the total erosion ratio increases with cavity width and particle diameter, while it decreases with inlet velocity. According to the fitted results, a simple erosion formula is proposed and validated by the CFD results in another 16 orthogonal experiments. Furthermore, the formula is improved for various values of Brinell hardness of carbon steel and sharpness factors of particles.

CFD Simulation and Erosion Prediction for the Flow Influence of Inserted Component of Pipes

Coarse-grained CFD-DEM Simulation of Elbow Erosion Induced by Dilute Gas-Solid Flow: A Multi-Level Study

Numerical Studies on Filter of Piping in Broadly Graded Cohesionless Soils

Numerical simulation of 3-D turbulent flows in a cut-off valve and analysis of flow characteristics in pipe

Numerical Investigation of Silted-Up Dam-Break Flow with Different Silted-Up Sediment Heights

Multi-Scale Simulation of Fluid-Structure Interaction Induced Erosion on the Pipe Surface

Three-dimensional numerical investigation of solid particle erosion in gate valves

Failure analysis and prediction of pipes due to the interaction between multiphase flow and structure

Sand erosion prediction model for two-phase flow pipe bends and its application in gas-liquid-solid multiphase flow erosion

CFD-DEM Analysis of Hydraulic Conveying Bends: Interaction Between Pipe Orientation and Flow Regime

Numerical simulation of sand erosion in Venturi tube under different flow characteristics and sand content

Modeling of liquid-solid flow erosion in curved pipes of gradually varying cross section

Predicting Erosion-Corrosion Induced by the Interactions Between Multiphase Flow and Structure in Piping System

Investigation on the Erosion Characteristics of Liquid–Solid Two-Phase Flow in Tee Pipes Based on CFD-DEM

Application of Local Flow Models in Predicting Distributions of Erosion-Corrosion Locations

Fluid Simulation for Erosion Destroy of Petrifaction Pipe and its Application in Structure Optimized

Numerical Simulation and Analysis of Flow Field Characteristics for a 90-Degree Circular-section Dust Removal Pipeline

Simulation of Pipe Progression in A Levee Foundation with Coupled Seepage and Pipe Flow Domains

Erosion-corrosion Failure of REAC Pipes under Multiphase Flow

An algorithm combining sedimentation experiments for pipe erosion investigation

A Numerical Study of Turbulence Model and Rebound Model Effect on Erosion Simulations in an Electrical Submersible Pump (ESP)