Abstract:A new lower tungsten divertor has been developed and installed in the EAST superconducting tokamak to replace the previous graphite divertor with power handling capability increasing from <2 MW m−2 to ∼10 MW m−2, aiming at achieving long-pulse H-mode operations in a full metal wall environment with the steady-state divertor heat flux of ∼10 MW m−2. A new divertor concept, ‘corner slot’ (CS) divertor, has been employed. By using the ‘corner effect’, a strongly dissipative divertor with the local buildup of high neutral pressure near the corner can be achieved, so that stable detachment can be maintained across the entire outer target plate with a relatively lower impurity seeding rate, at a separatrix density compatible with advanced steady-state core scenarios. These are essential for achieving efficient current drive with low-hybrid waves, a low core impurity concentration and thus a low loop voltage for fully non-inductive long-pulse operations. Compared with the highly closed small-angle-slot divertor in DIII-D, the new divertor in EAST exhibits the following merits: (1) a much simpler geometry with integral cassette body structure, combining vertical and horizontal target plates, which are more suitable for actively water-cooled W/Cu plasma facing components, facilitating installation precision control for minimizing surface misalignment, achieving high engineering reliability and lowering the capital cost as well; (2) it has much greater flexibility in magnetic configurations, allowing for the position of the outer strike point on either vertical or horizontal target plates to accommodate a relatively wide triangularity range, δ l = 0.4–0.6, thus enabling to explore various advanced scenarios. A water-cooled copper in-vessel coil has been installed under the dome. Five supersonic molecular beam injection systems have been mounted in the divertor to achieve faster and more precise feedback control of the gas injection rate. Furthermore, this new divertor allows for double null divertor operation and slowly sweeping the outer strike point across the horizontal and vertical target plates to spread the heat flux for long-pulse operations. Preliminary experimental results demonstrate the ‘corner effect’ and are in good agreement with simulations using SOLPS-ITER code including drifts. The EAST new divertor provides a test-bed for the closed divertor concept to achieve steady-state detachment operation at high power. Next step, a more closed divertor, ‘sharp-cornered slot’ divertor, building upon the current CS divertor concept, has been proposed as a candidate for the EAST upper divertor upgrade.

Development Progresses of EAST Neutral Beam Injector

Conceptual design of 5 MW-NBI injector for HL-2 M tokamak

Overview of Development Status for EAST-NBI System

High-Power Ion Beam Characteristics of a Magnetic Multi-Pole Line-Cusp Ion Source for the HL-2A Tokomak

The Influence of Neutral Beam Injection on the Heating and Current Drive with Electron Cyclotron Wave on East

Recent Progress in Chinese Fusion Research Based on Superconducting Tokamak Configuration

Beam Optics Analysis for the 120-keV Multiaperture Accelerator of Neutral Beam Injector

Injection Performance Prediction Of The Upgraded Neutral Beam On East

Development of a compact torus injector system for central fuelling technology of EAST

Fully Active Cooled In-vessel Components of EAST Tokamak

Power Balance Investigation in Long-Pulse High-Performance Discharges with ITER-like Tungsten Divertor on EAST

Advances in the Long-Pulse Steady-State High Beta H-mode Scenario with Active Controls of Divertor Heat and Particle Fluxes in EAST

Simulations of Neutral Beam Injection and Ion Cyclotron Resonance Heating Synergy in High Power EAST Scenarios

Design and Platform Testing of the Compact Torus Central Fueling Device for the EAST Tokamak

Overview of recent experimental results on the EAST tokamak

The R&D progress of 4 MW EAST-NBI high current ion source

Neutron Emission and Fast Ion Simulation for High Performance Long Pulses at EAST.

Recent EAST Experimental Results and Systems Upgrade in Support of Long-Pulse Steady-State Plasma Operation

Simulation of EAST off-axis neutral beam heating and current drive

Towards a maintainable and high efficiency neutral beam system for future fusion reactors

Physics Design of New Lower Tungsten Divertor for Long-Pulse High-Power Operations in EAST