Abstract:Abstract A radiofrequency (RF) ion source with a megawatt power extraction, thunder I, has been developed for the neutral beam injector (NBI) on HL-2A tokamak. A full solid-state RF generator with output power of 80 kW and frequency of 2 MHz was built by an RF combiner using 8 modules of solid-state RF generator with power of P RF = 10 kW. The line electric efficiency of whole RF generator reaches 92% and its voltage standing wave ratio (VSWR) is 1.01, thus no water-cooling system is supplied. A quartz vessel with the inner diameter of 250 mm is directly adopted for resisting atmospheric pressure, which can dramatically simplify source structure. Nowadays, the extracted beam parameters of RF hydrogen ion source are 32 kV/20 A/0.1 s on a test bed, while the design parameters are 50 kV/20 A/3 s. The beam density profile measured by the infrared imaging technique at 1.3 m downstream from the grounded grid obeys a Gaussian distribution, and the corresponding half width of 1/ e power decay at the matched condition is about 80 mm. Plasma homogeneity is over 90% at low RF power. The beam divergence angle meets the requirement of NBI system on HL-2A tokamak. The extractable current density increases almost linearly with the RF power. It reaches 2400 A m −2 at P RF = 32 kW. The ion density in front of plasma grid is about 1 × 10 18 m −3 , corresponding to an ionized fraction of about 1% at the gas pressure of 0.5 Pa. Single hydrogen ion fraction reaches 79% at the beam current of 12.4 A. Some improvements have been considered for optimizing ion source performance on next experimental campaign. One smaller auxiliary RF discharge chamber equipped with a gas feed path, driven by 13.56 MHz/3.5 kW generator, is connected to main discharge chamber driven by 2 MHz/40 kW generator. By this dual-driven configuration, the innovative RF plasma source with high-pressure density gradient solves the initial ignition problem of powerful RF ion source even if the gas pressure below 0.1 Pa. In addition, the RF negative hydrogen ion source of 200 kV/20 A/3600 s is also developed at SWIP for the China fusion engineering test reactor.

High-Power Ion Beam Characteristics of a Magnetic Multi-Pole Line-Cusp Ion Source for the HL-2A Tokomak

Conceptual design of 5 MW-NBI injector for HL-2 M tokamak

Proton Ratio of Hl-2a Bucket Ion Source

Plasma behaviour with hydrogen supersonic molecular beam and cluster jet injection in the HL-2A tokamak

OV / 4-5 1 Overview of Experimental Results on the HL-2 A Tokamak

Overview of Hl-2a Experiment Results

Development of megawatt radiofrequency ion source for the neutral beam injector on HL-2A tokamak

1 EX / P 3-21 Plasma Behavior with Hydrogen Supersonic Molecular Beam and Cluster Jet Injection in the HL-2 A Tokamak

High current H2(+) and H3(+) beam generation by pulsed 2.45 GHz electron cyclotron resonance ion source.

Development of a 50 kV hydrogen–helium mixed ion beam implanter

Beam Optics Analysis for the 120-keV Multiaperture Accelerator of Neutral Beam Injector

Design of a Beam Line for Simultaneous Dual-Beam Ion Implantation

Update of ion-optical system of neutral beam of Tokamak à Configuration Variable

Characterization of 1 MW, 40 keV, 1 s neutral beam for plasma heating

Status of the Los Alamos heavy ion injector

Beam-dynamics Design of a 2 MeV/u Heavy-Ion IH-DTL with Electromagnetic Quadrupole Structure

An ion species model for positive ion sources - part I description of the model

High current $\mathrm{H}_2^+$ beams from a filament-driven multicusp ion source

Possibility of Generating H+, or H2+, or H3+ Dominated Ion Beams with a 2.45 GHz Permanent Magnet ECR Ion Source

The R&D progress of 4 MW EAST-NBI high current ion source

Development of a Radio-Frequency Quadrupole Accelerator for the HL-2A/2M Tokamak Diagnostic System