Abstract:Abstract A radiofrequency (RF) ion source with a megawatt power extraction, thunder I, has been developed for the neutral beam injector (NBI) on HL-2A tokamak. A full solid-state RF generator with output power of 80 kW and frequency of 2 MHz was built by an RF combiner using 8 modules of solid-state RF generator with power of P RF = 10 kW. The line electric efficiency of whole RF generator reaches 92% and its voltage standing wave ratio (VSWR) is 1.01, thus no water-cooling system is supplied. A quartz vessel with the inner diameter of 250 mm is directly adopted for resisting atmospheric pressure, which can dramatically simplify source structure. Nowadays, the extracted beam parameters of RF hydrogen ion source are 32 kV/20 A/0.1 s on a test bed, while the design parameters are 50 kV/20 A/3 s. The beam density profile measured by the infrared imaging technique at 1.3 m downstream from the grounded grid obeys a Gaussian distribution, and the corresponding half width of 1/ e power decay at the matched condition is about 80 mm. Plasma homogeneity is over 90% at low RF power. The beam divergence angle meets the requirement of NBI system on HL-2A tokamak. The extractable current density increases almost linearly with the RF power. It reaches 2400 A m −2 at P RF = 32 kW. The ion density in front of plasma grid is about 1 × 10 18 m −3 , corresponding to an ionized fraction of about 1% at the gas pressure of 0.5 Pa. Single hydrogen ion fraction reaches 79% at the beam current of 12.4 A. Some improvements have been considered for optimizing ion source performance on next experimental campaign. One smaller auxiliary RF discharge chamber equipped with a gas feed path, driven by 13.56 MHz/3.5 kW generator, is connected to main discharge chamber driven by 2 MHz/40 kW generator. By this dual-driven configuration, the innovative RF plasma source with high-pressure density gradient solves the initial ignition problem of powerful RF ion source even if the gas pressure below 0.1 Pa. In addition, the RF negative hydrogen ion source of 200 kV/20 A/3600 s is also developed at SWIP for the China fusion engineering test reactor.

Proton Ratio of Hl-2a Bucket Ion Source

High-Power Ion Beam Characteristics of a Magnetic Multi-Pole Line-Cusp Ion Source for the HL-2A Tokomak

Plasma behaviour with hydrogen supersonic molecular beam and cluster jet injection in the HL-2A tokamak

Overview of Hl-2a Experiment Results

High current H2(+) and H3(+) beam generation by pulsed 2.45 GHz electron cyclotron resonance ion source.

1 EX / P 3-21 Plasma Behavior with Hydrogen Supersonic Molecular Beam and Cluster Jet Injection in the HL-2 A Tokamak

An experimental investigation of the proton fraction in a three electrode 2.45 GHz ECR ion source

Modeling of ion cyclotron resonance frequency heating of proton-boron plasmas in EHL-2 spherical tokamak

Possibility of Generating H+, or H2+, or H3+ Dominated Ion Beams with a 2.45 GHz Permanent Magnet ECR Ion Source

High intensity proton source based on a hollow-cathode reflex discharge

Study on Proton Fraction of Beams Extracted from Electron Cyclotron Resonance Ion Source

Development of megawatt radiofrequency ion source for the neutral beam injector on HL-2A tokamak

Plasma Simulation of Hot-Surface-microwave Hybrid Ion Sources

Surface Enhancement of Molecular Ion ${{\rm{h}}}_{2}^{+}$ Yield in a 2.45-Ghz Electron–cyclotron Resonance Ion Source

Deuterium Plasma Diagnosis in a Miniature Penning Ion Source by a Single Probe

A compact low energy proton source

An ion species model for positive ion sources - part I description of the model

Plasma Characterization of a Test Setup of RF-driven Negative Ion Source by a Langmuir Probe System

A 2.45 Ghz Electron Cyclotron Resonance Proton Ion Source and A Dual-Lens Low Energy Beam Transport

OES Diagnostics of H2 Plasma in an Intense ECR Proton Source

Energy & mass-charge distribution peculiarities of ion emitted from penning source