Influence of Metallic Particles on the Flashover Characteristics of Pillar Insulator in SF6 Under Impulse Voltage

Xiangyu TAN,Xuandong LIU,Lingli ZHANG

DOI: https://doi.org/10.13296/j.1001-1609.hva.2017.09.035

2017-01-01

Abstract:With the high-speed development of power grid,insulation failures of gas insulated switchgear(GIS) at higher voltage level are increasingly frequent during its service.As the feeble part of GIS insulation,the breakdown accident of pillar insulator caused by its surface flashover happens frequently.In order to explore the reasons for insulator flashover fault,with the help of 1 MV steep-fronted impulse generator,we studied the influences of gas pressure and wave front time on the flashover voltage of pillar insulator with metallic conducting particles attached on its surface under double exponential impulse voltage.Results show that when the gas pressure is increased,the surface flashover voltage of the pillar insulator appears as a hump shaped curve and the critical pressure corresponding to the maximum value of negative hump curve is lower than that of positive hump shaped curve.In addition,the flashover with positive voltage has a single channel while that of negative voltage is circuitous and has numerous branches.With increasing pressure,flashover channels of both polar gradually become connected.When the wave front time is changed,the 50％ flashover voltage of the pillar insulator appears as a "U" sharped curve.The critical wave front time of the "U" sharped curve under negative impulse is shorter than that under positive impulse.From the analysis,the hump shaped curve is caused by "corona stabilization" effect of space charges in streamers.Because of the differences in the development process of positive and negative streamers,the flashover channels behave differently too.The "U" sharped curve is caused by the combined effect of discharge time lag,space charges and charges injected by displacement current.