Abstract:Surface charge accumulated on insulators plays an important role in flashover process in vacuum, which has not yet been fully understood. In this paper, charging behaviors on insulator surface were experimentally examined under negative DC and impulse voltage. For the case of DC voltage, two charging stages were observed, i.e., the area near cathode was at first negatively charged under lower voltage (stage I) and then followed by a positively charged cathode-anode surface (stage II). Surface charging at stage I is considered to be caused by Schottky injection of homo-charges from electrode into sample surface layer. While at stage II secondary electron emission (SEE) process is responsible to the positively charged anode-cathode surface. However, charging at stage I is quite sensitive to pre-stress process, as well as the electrode-insulator interface conditions. The ongoing injection of electrons from cathode can lead to gradually decreasing in surface charge accumulation as the voltage duration increases. For the case of impulse voltage, Schottky injection of homo-charges has little influence on surface charging as the time is too short for charge injection and migration in surface layer. The SEE process will govern surface charging due to its extremely fast establishment process. A good linear relationship is obtained between saturated surface charge density and applied voltage, which is generally consistent with the numerical calculation result based on secondary electron emission avalanche theory. At last, it is confirmed that the ionization of desorbed gas from insulator surface and subsequent neutralization of electrons with positive surface charge is the main cause to eliminate surface charge in flashover.

Quantitative Analysis on the Influence of Surface Charges on Flashover of Insulators in SF6

The Influence of Electric Field Distribution on Insulator Surface Flashover

Surface Charge Accumulation Behavior and Its Influence on Surface Flashover Performance of Al2O3-filled Epoxy Resin Insulators under DC Voltages

Study on Insulation Characteristics of GIS under Combined Voltage of DC and Lightning Impulse

Experimental Investigation of Surface Charge Accumulation Behaviors on PTFE Insulator under DC and Impulse Voltage in Vacuum

A Study on Flashover Characteristics of Supporting Insulators in SF6 under Lightning Impulse

Analysis on Surface Charging of Insulator Prior to Flashover in Vacuum

Influence of Metallic Particle on Flashover Characteristics of Post Insulator in SF6 under Negative DC Voltage

Flashover Characteristics along the Insulator in SF6 Gas under DC Voltage

Research Status of Insulators Along-Surface Flashover Property in SF6 Alternative Gas

Influence of Metallic Particles on the Flashover Characteristics of Pillar Insulator in SF6 Under Impulse Voltage

Influence of metallic particle on flashover characteristics of post insulator in SF 6 under negative DC voltage

Investigation on Surface Electric Field Distribution Features Related to Insulator Flashover in SF 6 Gas

Influence of Epoxy Resin Insulator Structure on Its Flashover Characteristics in SF6

Influence of DC Voltage Component on Surface Flashover of Insulating Screw under Composite AC and DC Voltage

Influence of Metal Particle Contamination on Surface Charging and Flashover Characteristics of PTFE Insulator under Impulse Voltage in Vacuum

Surface Flashover Characteristics of Oil-Paper Insulation under Combined AC-DC Voltage

Monte Carlo Based Simulation on Surface Charging Phenomena of Insulators Prior to Flashover in Vacuum

Measurement of surface charge distribution on insulating material under pulsed voltage

Statistical analysis on the DC discharge path of ice-covered insulators under natural conditions

Measurements of Electric Field and Charge on Insulator Surface