Abstract:Surface charge accumulated on insulators plays an important role in flashover process in vacuum, which has not yet been fully understood. In this paper, charging behaviors on insulator surface were experimentally examined under negative DC and impulse voltage. For the case of DC voltage, two charging stages were observed, i.e., the area near cathode was at first negatively charged under lower voltage (stage I) and then followed by a positively charged cathode-anode surface (stage II). Surface charging at stage I is considered to be caused by Schottky injection of homo-charges from electrode into sample surface layer. While at stage II secondary electron emission (SEE) process is responsible to the positively charged anode-cathode surface. However, charging at stage I is quite sensitive to pre-stress process, as well as the electrode-insulator interface conditions. The ongoing injection of electrons from cathode can lead to gradually decreasing in surface charge accumulation as the voltage duration increases. For the case of impulse voltage, Schottky injection of homo-charges has little influence on surface charging as the time is too short for charge injection and migration in surface layer. The SEE process will govern surface charging due to its extremely fast establishment process. A good linear relationship is obtained between saturated surface charge density and applied voltage, which is generally consistent with the numerical calculation result based on secondary electron emission avalanche theory. At last, it is confirmed that the ionization of desorbed gas from insulator surface and subsequent neutralization of electrons with positive surface charge is the main cause to eliminate surface charge in flashover.

Measurement of surface charge distribution on insulating material under pulsed voltage

Measurements of Electric Field and Charge on Insulator Surface

Comparison of surface charge distributions under vacuum and atmospheric condition due to surface discharge events

Analysis on Surface Charging of Insulator Prior to Flashover in Vacuum

Spectrum measurement of surface flashover under high voltage nanosecond pulse

Non-invasive surface potential measurement of surface flashover

Experimental Investigation of Surface Charge Accumulation Behaviors on PTFE Insulator under DC and Impulse Voltage in Vacuum

Review of Surface Transient Charge Measurement on Solid Insulating Materials Via the Pockels Technique

Investigation on Novel Characterization Parameters of Surface Flashover Phenomena in Vacuum

An electro-optical measurement on electric field of insulator surface under HV pulse in vacuum

Monte Carlo Simulation of Surface-Charging Phenomena on Insulators Prior to Flashover in Vacuum

Initial Conditions of Surface Charge Accumulation under Impulse Voltage

Research Progress on Surface Flashover Phenomena Across Solid Insulation in Vacuum

Monte Carlo Based Simulation on Surface Charging Phenomena of Insulators Prior to Flashover in Vacuum

Characteristics of Residual Charge Distribution on Insulator Surface under DC Voltage in Vacuum

Research Progress on Vacuum Surface Flashover of Solid Dielectrics

In-situ Measurement of Surface Charge of a Positive Pulse Surface Discharge in SF<sub>6</sub>

Surface Charging and Flashover of Solid Cross Linked Polystyrene Excited by Nanosecond Pulse in Vacuum

Surface and Interface Physical Phenomena Induced by Flashover Across Solid Dielectrics in Vacuum

Surface Charge Accumulation Behavior and Its Influence on Surface Flashover Performance of Al2O3-filled Epoxy Resin Insulators under DC Voltages

Measurement of Surface Potential Distribution of Fluorinated Polyimide Film