Abstract:The sol adhesion method prepared an all-solid ultralow noise electric field sensor. Compared with the sintering method, electrolysis method, and ball milling method, the content of Ag (silver) and AgCl (silver chloride) stays at a high-level amount, the mixture is more uniform and there are no impurities introduced in the fabrication process. Some experiments were designed to characterize the basic properties and electrochemical characteristics of the electrode. Scanning electron microscope (SEM) shows the produced Ag/AgCl (silver and silver chloride) has small particle sizes and a large contact area. The potential drifts of electrodes are less than V. The self-potential is less than V. Self-noise of the electrode is 1.99 nV/ Hz@1 Hz. Meanwhile, the electrode responds well to electric field signals from 0.1 Hz to 3 kHz and can detect small amplitude signals to 2 mV without distortion. The electrode has the advantages of low impedance, low noise, high sensitivity, and high stability. The self-potential test showed the Ag/AgCl electrodes spent less than 20 min to reach stability is at least three times faster than that of Cu, Ag, Pb/PbCl, and stainless-steel electrodes. Stability potential and range drift are at least 98% and 93% lower than that of other electrodes. In the telluric test, the signal amplitude is at least four times of Ag and Pb/PbCl electrodes. In the marine test, the signal amplitude value is 4 mV level with the noise amplitude value is 0.06 mV level. It shows the good performance of the electrodes. This study is of great significance in accurately measuring marine and telluric electric fields.

A novel sensor for marine electric field measurement: Study and design

Low Noise CMOS Front-End Amplifier Used in Detection of Extracellular Neural Signals (ENG)

System Design of a Low Noise, Low Offset Instrumentation Amplifier with Chopper Stabilization

A Low-Noise Amplifier for Submarine Electric Field Signal Based on Chopping Amplification Technology

Development of a New Kind Low Frequency Low-Noise Vector Sensor

Ultralow-Noise Chopper Amplifier for Seafloor E-Field Measurement

An Integrated Low 1/f Noise and High-Sensitivity CMOS Instrumentation Amplifier for TMR Sensors

All-Solid Ultralow Noise Electric Field Sensor Based on the Sol Adhesion Method for Telluric and Marine Electrode Field Detection

Ultra-sensitive magnetic field sensor based on a low-noise magnetoelectric MEMS-CMOS oscillator

A high-resolution tunneling magneto-resistance sensor interface circuit

Ultrasensitive modulated magnetoelectric sensors and low noise readout circuits for DC and very low frequency weak magnetic signal detection

Design of a Low-Noise Multi-Range Broadband Front-End Amplifier for MEMS Electric Field Sensor

A low-noise charge sensitive amplifier for MEMS capacitive sensors

Design and experiment of broadband electric field sensor for high-power sub-nanosecond pulse measurements

Research on Self-Noise Suppression of Marine Acoustic Sensor Arrays

A Direct-Reading MEMS Conductivity Sensor with a Parallel-Symmetric Four-Electrode Configuration

Design of an Electro-Optic Integrated Electric Field Sensor

An Integrated Miniature Conductivity And Temperature Sensor Chip With Open-Cell Annular Electrode

A Durable and Self-Powered Triboelectric Sensor for Hydraulic Pressure Monitoring and Underwater Disturbance Detection

A Novel MEMS Chip-based Ground Atmospheric Electric Field Sensor

Low-noise multi-channel underwater electric field measurement and analysis system for a ship model