Abstract:We have systematically studied Zinc Oxynitride (ZnON) materials for thin film transistors in advanced display applications. The ZnON materials were deposited using a reactive sputtering process with a metallic Zn target in a gas mixture of Ar, N2 and O2. We previously optimized the gas mixture and RF power and found optimized process parameters for O2 and N2 flow rates and RF power. In this contribution, we report the material properties as a function of process pressure and temperature. We observed that at a relatively lower pressure of 5 mTorr, the material shows a cubic Zn3N2-like structure with a narrow band gap of 1.1 eV, high conductivity, high carrier density, and high carrier mobility; at medium pressure of approximately 13-15 mTorr, the material becomes nanostructured or amorphous ZnON (nc-ZnON or a-ZnON) with a band gap of approximately 1.3-1.5 eV; and at pressures higher than 20 mTorr, the material shows a hexagonal polycrystalline ZnO-like structure with a band gap of 3.1 eV. The deposition rate decreases but the band gap increases monotonically with increasing pressure; the Hall electron mobility decreases with increasing pressure in the range from 5 mTorr to 13 mTorr and changes very little in the high pressure regime; the conductivity and carrier density decrease with the increase of pressure from 5 mTorr to 17 mTorr and then increase with further increase of pressure, which is related to the material structure changes from Zn3N2-like to a-ZnON, and then to ZnO-like materials. The substrate temperature has little effect on the material properties. Increasing substrate temperature slightly increases the band gap, carrier concentration, and conductivity, but slightly decreases the carrier mobility. Finally, under the optimized conditions, the nc-ZnON films are made with an optical band gap of 1.3-1.5 eV, electron mobility above 80 cm2/Vs and electron density of 1 × 1018 cm-3, which are suitable for high quality TFTs in advanced display applications.

Effects of Substrate Temperature on ZnO-TFT Based on Bi1.5 Zn1.0 Nb1.5O7 Insulating Layer

The Effects of Oxygen Partial Pressure and Substrate Temperature on the Structural and Optical Properties of Zno Films

Effect of Annealing Temperature of Bi1.5Zn1.0Nb1.5O7gate Insulator on Performance of ZnO Based Thin Film Transistors

Effect of Sputtering Power on Properties of ZnO Thin Film Transistors with Bi1.5Zn1.0Nb1.5O7 Gate Insulator

Study on the Electrical Properties of Zno Thin Film Transistors Using Pyrochlore Bi1.5zn(1+Y)Nb1.5o(7+Y) Gate Insulators Fabricated by Rf Sputtering

Effect of Excess Bi2o3 on Structure and Performance of Zno-Based Thin Film Transistors

Effects of Substrate Temperature on Performance of Calcium-Doped Zinc Oxide Tfts

Effects of Growth Temperature and Annealing on Properties of Zn3sn2o7 Thin Films and Application in Tfts

Temperature Dependence of the Electrical Characteristics of ZnO Thin Film Transistors

Comparison of Structural and Optical Properties of ZnO Films Grown on Different Substrates at Low Temperatures

Effects of Annealing Process on Characteristics of Fully Transparent Zinc Tin Oxide Thin-Film Transistor

Effects of substrate temperature on the properties of heavy Ga-doped ZnO transparent conductive film by RF magnetron sputtering

Influence Of Substrate Temperature On The Structure And Electric Properties Of Zno Films

Properties of boron-doped ZnO thin films deposited by pulsed DC magnetron sputtering at different substrate temperatures

High-performance ZnO Thin-Film Transistors Prepared by Atomic Layer Deposition at Low Temperature

Feasibility of Atomic Layer Deposited AlZrOx Film to Achieve High Performance and Good Stability of ZnSnO-TFT

Influence of Substrate Temperature on Structures and Dielectric Properties of Pyrochlore Bi1.5Zn1.0Nb1.5O7 Thin Films Prepared by Pulsed Laser Deposition

Effects of Substrate Temperature on Structure and Properties of Al-F Co-doped ZnO Thin Films

Temperature dependence of the electrical characteristics of ZnO thin film transistor with high-k NbLaO gate dielectric

Effect of Substrate Temperature on the Properties of Transparent Conductive Zno:Al Thin Films Prepared by Rf Sputtering

Effect of Process Pressure and Temperature on ZnON Material Properties in Reactive Sputtering