Abstract:Eddy current testing (ECT) is one of the most important techniques in nondestructive evaluation. A higher probe sensitivity is always pursued in ECT. To improve the probe sensitivity, the near electrical resonance signal enhancement (NERSE) technique was recently proposed. In the NERSE technique, a coaxial cable connecting with the probe coil is introduced to provide a capacitance for the electrical resonance. However, the long coaxial cable is awkward and inconvenient in engineering applications, restraining the usability of such probes. Metamaterials (MTMs) are novel artificial electromagnetic media and have been proved to be effective in manipulating the impedance of a solenoid coil. In other words, in principle, MTMs can be used in the same way as that a coaxial cable in NERSE in ECT. Based on this argument, low-frequency magnetic MTMs are introduced as the probe cores to provide a new approach to achieve the electrical resonance for the NERSE technique. A promising feature of the proposed approach is that the detecting signals and sensitivity are significantly increased due to the extraordinary electromagnetic properties of the MTM. The most salient features of an MTM core over a ferrite core are: 1) effective permeability of the MTM core will vary sharply from a high positive to a high negative values when crossing the resonance frequency, resulting in not only a high magnetic flux density in the tested material but also an extremely large variation of the normalized impedance which is very essential in identifying a crack and 2) electromagnetic properties of an MTM will increase with the increase of frequency, whereas those of a ferrite material usually degrade sharply with the increase of frequency. To demonstrate the advantages of the proposed new probe, comprehensive numerical and experimental studies are conducted, and the results have shown the high performance of the proposed probe. In addition, the proposed MTM-core probe also exhibits a diverse versatility and convenience in engineering applications as compared with the existing NERSE technique.

Optimum Design of Probe for Electric Properties Reconstruction of Tissues

Accurate Evaluation of RF Coil-Tissue Interactions Using a Hybrid FDTD-MoM Method

High-resolution Probe Design for Measuring the Dielectric Properties of Human Tissues

A Wideband and High Sensitivity Probe Design for Near-Field Scanning

Optimum Design for Capacitively Coupled Electrical Resistance Tomography Sensor Configuration

A Miniature Electric Probe with a High Spatial Resolution

A Miniature Multi-Component Probe for Near-Field Scanning

A New Scheme of Embedded RF Probe an Embedded Three-Port Loop of RF Parameters Detection

Analytical Modeling for Probe Impedance Using Reflection and Transmission Theory in Eddy Current Testing

Design of Microstrip Line used for Probe Calibration up to 40 GHz

Probe Design and Source Reconstruction for Near-Field Scanning and Modeling

A Wideband Tangential Electric Probe Based on Common Mode Absorbing

Research on the Best Measurement Situation Between Optical Probe and Tissue Surfaces in Non-Invasive Detection.

A High-Frequency and High Spatial Resolution Probe Design for EMI Prediction

A Wideband EzEx Field Probe Integrated with a Strip Line Magic-T

Metamaterial-Core Probes for Nondestructive Eddy Current Testing.

An Efficient Probe Calibration Based Near-Field to Near-Field Transformation for EMI Diagnosis

Designs of Eddy Current Sensor Probes Based on Multi Layer Printed Circuit Board Technology

A Wideband Dual-Component Electric Probe for Near-Field Measurement

Design and simulation of a 2-D array flexible ultrasound transducer system for tissue characterization – A pilot study

Design and Characterization of a Multi-Processed Differential Magnetic Field Probe by Using Asymmetric Calibration Method