Abstract:This paper proposes a modified predictive direct torque control (MPDTC) application-specific integrated circuit (ASIC) with multistage hysteresis and fuzzy controller to address the ripple problem of hysteresis controllers and to have a low power consumption chip. The proposed MPDTC ASIC calculates the stator's magnetic flux and torque by detecting three-phase currents, three-phase voltages, and the rotor speed. Moreover, it eliminates large ripples in the torque and flux by passing through the modified discrete multiple-voltage vector (MDMVV), and four voltage vectors were obtained on the basis of the calculated flux and torque in a cycle. In addition, the speed error was converted into a torque command by using the fuzzy PID controller, and rounding-off calculation was employed to decrease the calculation error of the composite flux. The proposed MDMVV switching table provides 294 combined voltage vectors to the following inverter. The proposed MPDTC scheme generates four voltage vectors in a cycle that can quickly achieve DTC function. The Verilog hardware description language (HDL) was used to implement the hardware architecture, and an ASIC was fabricated with a TSMC 0.18 μm 1P6M CMOS process by using a cell-based design method. Measurement results revealed that the proposed MPDTC ASIC performed with operating frequency, sampling rate, and dead time of 10 MHz, 100 kS/s, and 100 ns, respectively, at a supply voltage of 1.8 V. The power consumption and chip area of the circuit were 2.457 mW and 1.193 mm × 1.190 mm, respectively. The proposed MPDTC ASIC occupied a smaller chip area and exhibited a lower power consumption than the conventional DTC system did in the adopted FPGA development board. The robustness and convenience of the proposed MPDTC ASIC are especially advantageous.

Direct Torque Control of 3-Phase Asynchronous Motor Based on ASIPM

Torque Ripple Suppression Control for Dual Three-Phase Permanent-Magnet Synchronous Motor

Direct Torque Control for 2L-VSI PMSM Using Switching Instant Table.

An Effective Direct Torque Control Based on Space Vector Modulation for DTP-PMSM

Optimized Direct Instantaneous Torque Control for SRMs With Efficiency Improvement

High-Power-Factor Control Of Ipmsm Drive System With Small Dc-Link Capacitor

New Torque Direct Control Scheme Of Induction Machines And Its Dsp-Based Implementation

Low-Cost Direct Instantaneous Torque Control for Switched Reluctance Motors with Bus Current Detection under Soft-Chopping Mode

Design of a Three-Phase Hybrid Stepping Motor Pulse Subdivision Controller Based on DSP

Implementation of Direct Torque Control Scheme for Induction Machines with Variable Structure Controllers

Direct Torque Control for Brushless DC Motors in Aerospace Applications with Single Sided Matrix Converters with Reduced Torque Ripple

A high efficiency direct instantaneous torque control of SRM using commutation angles control

Direct Torque Control Combined with Mtpa Concept for Open Winding Ipmsm

Fully-Digitized Direct Torque Control for Asynchronous Motors

Direct Power Control of Three-phase PWM Rectifier Based on DSP

Direct Torque Control for Three-Phase Open-End Winding PMSM With Common DC Bus Based on Duty Ratio Modulation

Modeling and Analysis of the Direct Torque Control System for IPMSM Fed by Three-Phase Four-Switch Inverter

A Novel Switching-Table-Based Direct Torque Control with Improved Current and Torque Steady-State Performance for Dual Three-Phase PMSM

Direct Torque Control of Induction Motor Fed by Three Level Inverter (I)--Single Vector Method

Direct Torque Control Schemes for Dual Three-Phase PMSM Considering Unbalanced DC-link Voltages

Modified Predictive Direct Torque Control ASIC with Multistage Hysteresis and Fuzzy Controller for a Three-Phase Induction Motor Drive