Abstract:Under the background of dual-carbon target, the circulating fluidized bed combustion technology, as an important part of coal-fired power generation, realizes an efficient and clean utilization of inferior fuel and is also a main force to participate in deep peak regulation of power grid in the future. However, CFB boilers still have a lot of room for improvement in load regulation rate, NO x emission control at deep low and low loads, and heating surface wear. Therefore, the powdered coal circulating fluidized bed（PC-CFB） combustion technology is proposed. By reducing the fuel particle size from the wide sieve distribution of 0-10 mm to a narrow sieve distribution of 0-1 mm, a sufficiently high circulating flow rate can be achieved at a low bed stock. Regulating chemical reactions through flow regimes, the reducing atmosphere needed for low-NO x combustion is strengthened, and the residence time of fine limestone in the furnace is extended, the combustion performance of the boiler can also be improved. More importantly, the rate of change in chemical reaction, i.e. heat release, increases due to the decrease of fuel particle size. Supplemented by cyclic interventions that can increase the rate of change in heat transfer rate, the combination of which can improve the rate of load regulation. The change of fuel particle size inevitably leads to the reduction of bed particle size, and significantly improves the deep low load capability and the in-furnace control of NO x emissions at low loads. This idea is confirmed by the modelling prediction, which shows that when the range of fuel particle size is reduced from the conventional size distribution to 0-1 mm, the average bed particle size decreases greatly and the material concentration in the dilute phase zone increases, and the circulating flow rate increases by about 27%. The reducing atmosphere in the furnace is enhanced, and the original emission concentration of NO x is reduced by about 35%. The improved performance of the circulation system can prolong the residence time of fine limestone in the furnace, improve the efficiency of desulfurization reaction, and reduce the original SO 2 emission concentration under the same conditions of calcium-sulfur ratio and NO x emission. Meanwhile, the combustion efficiency is significantly improved, the carbon content of bottom slag is reduced by 89%,and the heat loss of incomplete solid combustion is reduced by 52%,indicating that PC-CFB combustion technology has more advantages in enhancing the operational flexibility of CFB boilers, strengthening the low-NO x combustion, and improving the combustion performance.

Cold Mixing Characteristics of Solid Particles Based on the Coal Pyrolysis with Circulating Ash Heat Carrier

Cold Simulation Analysis of Flow Characteristics of High-Temperature Mixture in a Moving-Bed Reactor

Study on the low temperature coal pyrolysis by solid heat carrier in a moving bed pyrolyzer

Flow Characteristics of Mixed Particles with a Simulated Cold State in Moving Bed Reactor

Simulation of Large Coal Particles Pyrolysis by Circulating Ash Heat Carrier Toward the Axial Dimension of the Moving Bed

Computational Fluid Dynamics-Discrete Element Method Investigation of Solid Mixing Characteristics in an Internally Circulating Fluidized Bed

Theoretically Studies of the Coal Particle Cluster Combustion Behavior in a Circulating Fluidized Bed

Dense-phase pneumatic conveying of ash in the co-generation technology of CFB combustion combined with coal pyrolysis

Particle-Scale Simulation of Solid Mixing Characteristics of Binary Particles in a Bubbling Fluidized Bed

The characteristic research of Shenmu coal pyrolysis by solid heat carrier

Experimental Study on the Bubble Formation Mechanism During the Sintering of Coal and Biomass Ash Blends

Experimental Research of Igniting Characteristics in Circulating Fluidized Bed

Experimental Investigation On Three Coals Ash Formation

12th International Conference on Fluidized Bed Technology EFFECT OF ADDITIVES ON THE ASH FUSION TEMPERATURE

Mass Balance Performance Of A 300mw Cfb Boiler Burning Blend Fuel With Different Mixing Ratio

Three-dimensional simulation of gas-solid mixing behavior in thermal plasma reactor for coal pyrolysis

Sulfur Transfer Characteristics and Pyrolysis Simulation in the Coal Polygeneration Process

Powdered Coal Circulating Fluidized Bed Combustion Technology

Investigation of non-uniform characteristics in a 300 MWth circulating fluidized bed with different coal feeding modes

Ash formation characteristics in co-combusting coagulation sludge and Zhundong coal

Pilot Development of Polygeneration Process of Circulating Fluidized Bed Combustion Combined with Coal Pyrolysis