Abstract:To investigate the effects of circulating ash heat carriers and dolomite catalysts on sulfur migration in the coal pyrolysis/circulating fluidized bed combustion staged conversion process, five experiments of coal pyrolysis, ash/coal co-pyrolysis, coal pyrolysis catalyzed by dolomite, ash/coal co-pyrolysis catalyzed by dolomite and combustion of pyrolysis solid products were designed and carried out. By examining the effects of pyrolysis temperature, heating rate, ash-coal ratio and dolomite species on sulfur migration, the final distribution of sulfur-containing pollutants throughout the staged conversion process was systematically analyzed. The results showed that the separate mixing of ash heat carrier at final pyrolysis temperature of 600 °C increased the residual sulfur in solid phase from 79.29% of raw coal pyrolysis to 90.00%. When dolomite catalyst was added individually, the sulfur released into gas phase and tar was reduced from 18.28% and 2.43% of the raw coal to 13.14% and 1.94%, respectively. And Fe additive significantly improved sulfur resistance of the dolomite catalyst. The regeneration process has little effect on the sulfur fixation capacity of natural dolomite. When ash heat carrier and dolomite catalyst were simultaneously added to the system, the sulfur fixed in ash increased from 79.29% of the raw coal to 91.27%, and the sulfur fixed in natural dolomite and modified dolomite accounted for 4.32% and 4.46% of the total sulfur, respectively. In the combustion experiments of pyrolysis solid phase products, 43.57%, 65.57% and 61.44% of sulfur was retained in the solid phase residue after combustion with circulating ash, circulating ash/natural dolomite and circulating ash/modified dolomite were added, respectively. Compared with direct combustion of coal, the staged conversion process resulted in a 55% reduction of sulfur in the boiler flue gas. This study provides a theoretical basis for the purification of sulfur-containing pollutants in the staged conversion process.

Sulfur Transfer Characteristics and Pyrolysis Simulation in the Coal Polygeneration Process

Sulfur Transformation in the Process of Circulating Fluidized Bed Combustion Combined with Coal Pyrolysis

Effect of Circulating Ash on Sulfur Conversion Characteristics in the Coal Polygeneration Process

Sulfur Transformation During Coal Pyrolysis with Char Heat Carrier

Simulation of Large Coal Particles Pyrolysis by Circulating Ash Heat Carrier Toward the Axial Dimension of the Moving Bed

Mechanism of sulfur migration and conversion in pyrolysis/combustion staged conversion process of high sulfur coal

Sulfur Behavior of Coal and Ash during Coal Pyrolysis Combined with Combustion

ICOPE-15-C140 Effects of Mineral and Coal Ash on Sulfur Transformation in the Coal Staged Conversion Process

Modeling of Sulfur Retention in Circulating Fluidized Bed Coal Combustors

Sulfur Transformation During the Pyrolysis of Coal Mixed with Coal Ash in a Fixed Bed Reactor

Secondary Catalytic Reaction of Circulating Ash on the Primary Volatiles of Coal Pyrolysis

Pilot Development of Polygeneration Process of Circulating Fluidized Bed Combustion Combined with Coal Pyrolysis

High-Temperature Sulfur Removal Under Fluidized-Bed Combustion Conditions - A Chemical Interpretation

Research on Coal Pyrolysis Property for Polygeneration Technology

Experimental Investigation on Sulfur Transformation During Coal Steam Gasification with Ca-based Absorbent

Sulfur Conversion of Mixed Coal and Gangue during Combustion in a CFB Boiler

Insight into reaction performance and product formation in a novel coal pyrolyzer of pilot-scale test

Experimental Study on 75 T/h Circulating Fluidized Bed Poly-generation System

Experiments of Sulfur Removal in 1MW Poly-Generation System with Partial Gasification and Combustion Combined

Experiment of Sulfur Removal in 1MW Poly-Generation System with Air Gasification and Combustion Combined

Characteristics of Coal Partial Gasification on A Circulating Fluidized Bed Reactor