Influence of Mass Ratio of Asphalt to Cement on Fracture Toughness of Emulsified Asphalt Cement Mortar

Chao WANG,Dehua DENG,Qiang YUAN
DOI: https://doi.org/10.14062/j.issn.0454-5648.2016.05.01
2016-01-01
Abstract:Based on the theory of fracture mechanics, the fracture behavior of emulsified asphalt cement (CA) mortar with different asphalt to cement mass ratios (mA/mC) were investigated. Their stress intensity factor, J integral and fracture energy were calculated based on the load–bending deflection and load–crack mouth open displacement curves obtained from the three-point bending test, respectively. Their compressive and bending strengths were also measured. The results show that both the strength and fracture performance of CA mortar are closely related to the mA/mC. With the increase of mA/mC, the strength of CA mortar decreases and the deformability (ductility) increases, thus, the fracture mode of CA mortar experiences a transition from quasi-brittle fracture to ductile fracture with the increase of mA/mC. CA mortars with mA/mC<0.5 exhibit a quasi-brittle fracture behavior, and whose fracture toughness can be characterized by fracture toughness KIc value deduced from the theory of linear elastic fracture mechanics. The addition of a small amount asphalt in cement mortar leads to the ductility increase slightly but the strength of CA mortar decrease greatly, hence, the KIc value of CA mortar with mA/mC=0.3 is 0.248 5 MPa×m1/2, that is about a half of KIc value of the cement mortar without asphalt. On the other hand, CA mortars with mA/mC≥0.5 exhibit a ductile fracture behavior due to the higher ductility, and whose fracture toughness should be characterized by JIc value deduced from the theory of elastic-plastic fracture mechanics. As the mA/mC increases from 0.5 to 0.9, the JIc value of CA mortar is slightly lowered from 39.222 to 34.848 J/m2, however, the fracture energy is enhanced from 31.97 to 46.37 N/m. It is considered that the asphalt phase improves the toughness of CA mortar mainly by increasing its ductility.
What problem does this paper attempt to address?