Influence of Loading Rate on Mechanical Properties of Cement Asphalt Mortars

Xiang-ming KONG,Yong-liang LIU,Pei-yu YAN
DOI: https://doi.org/10.3969/j.issn.1007-9629.2010.02.011
2010-01-01
Abstract:The influence of loading rate on the mechanical properties of two typical cement asphalt mortars(CAMs) with varied asphalt to cement ratio(m_A/m_C) was studied.Uniaxial compressive stress-strain curves of the two CAMs were tested by the MTS(material testing system) at different displacement rates ranging from 0.3 mm/min to 30.0 mm/min.The correlation between peak strength or elastic modulus and loading rate was acquired and experimental data were fitted to the presumed mathematical formula that is proven applicable for other materials.Thereby,the influence of displacement rates on the mechanical properties of such two different CAMs was successfully expressed quantitatively.The results indicate that the peak strength and the elastic modulus of CAMs with low m_A/m_C are obviously higher than those of CAMs with higher m_A/m_C.The former is characterized by brittleness while the later is known as a tough material.Although the peak strength and the elastic modulus of both CAMs tend to increase with the increasing loading rate,the rate-influencing factor of CAMs with high m_A/m_C is about 6 to 10 times of that of CAMs with low m_A/m_C.For CAMs with high m_A/m_C,the increased loading rate leads to a tough-brittle transition.
What problem does this paper attempt to address?