Abstract:Global and local gas liquid characteristics (gas hold-up, volumetric mass transfer coefficient), and flow field, mixing time of the liquid phase are investigated for various triple-impeller configurations. Four types of impellers (Rushton turbine (RT), hollow blade turbine (HBT), wide-blade hydrofoil impeller pumping down (WHd), and pumping up (WHu)) were used to form four combinations (3RT, HBT+2WHd, HBT+2WHu, and 3WHu). The results show that the axial impellers combination (3WHu) provides more effective homogenization performance than the impellers with combined radial and axial flow (HBT+2WHu, HBT+2WHd), while the radial impellers combination (3RT) is the worst. When the gas superficial velocity is 1.625 mm s(-1), 3WHu produces a 53% higher mass transfer coefficient than HBT+2VVHd, HBT+2WHu, and 3RT lie between them. When the gas superficial velocity reaches up to 8.124 mm s(-1) however, all of the tested configurations give almost similar mass transfer coefficients under equivalent power input. For 3RT, the highest hold-up is in the bottom impeller discharge stream and near the wall for the middle and top impellers. For the HBT+2WHd combination, there was no large variations of gas hold up in the bulk except the region around the bottom impeller. For HBT+2WHu and 3WHu, high gas hold-up was observed between the two up pumping impellers, and moderately low gas hold-up above the top impeller. There are three zones of higher interfacial area for the HBT+2WHu and 3RT combination, two zones of higher interfacial area for 3WHu, and only one zone of higher interfacial area for HBT+2WHd combination. At low gas velocity, the flow pattern generated by each impeller combination results in different gas bubble trajectory and different bubble breakup and coalescence kinetics, which in turn influences both local and average gas holdup directly, and also affects the local specific interfacial area, that is, influences the mass transfer coefficient indirectly. At higher gas velocity, the power drop also contributes to change of the gas hold-up and mass transfer at the same specific power consumption.

Mass transfer performance for multiple-impeller bioreactor in cold model and fermentation experiments

Micro-Mixing Enhancement in a Taylor-Couette Reactor Using the Inner Rotors with Various Surface Configurations

Study on Scale-Up of Anaerobic Fermentation Mixing with Different Solid Content

Computational fluid dynamics simulation of different impeller combinations in high viscosity fermentation and its application]

Fluid dynamics investigation of variant impeller combinations by simulation and fermentation experiment

A novel impeller configuration to improve fungal physiology performance and energy conservation for cephalosporin C production.

Experiments and a three‐phase computational fluid dynamics (CFD) simulation coupled with population balance equations of a stirred tank bioreactor for high cell density cultivation

Modeling of gas–liquid mass transfer in a stirred tank bioreactor agitated by a Rushton turbine or a new pitched blade impeller

Gas–liquid mixing performance of a non‐Newtonian fluid in a multiple‐impeller agitated tank

Evaluation of Mixing Effect and Shear Stress of Different Impeller Combinations on Nemadectin Fermentation

Experimental Analysis of the Mass Transfer Coefficient and Interfacial Area in an Aerated Coaxial Mixing System Comprising a Non-Newtonian Solution

Improvement of glucoamylase production using axial impellers with low power consumption and homogeneous mass transfer

CFD Simulation of Mixing Process in Stirred Bioreactor and Its Application in Fermentation

Power Consumption, Local and Average Volumetric Mass Transfer Coefficient in Multiple-Impeller Stirred Bioreactors for Xanthan Gum Solutions

Optimization of Curdlan Fermentation Process by Combining Impeller Combinations and Glucose Fed-Batch Modes

Characterizing the effect of impeller design in plant cell fermentations using CFD modeling

Flow Pattern, Mixing, Gas Hold-Up and Mass Transfer Coefficient of Triple-Impeller Configurations in Stirred Tank Bioreactors

Simultaneous saccharification and ethanol fermentation at high corn stover solids loading in a helical stirring bioreactor.

Mass transfer and bubble hydrodynamics in stirred tank with multiple properties fluid via a CFD‐PBM method

CFD-PBM Simulation and Scale-Up of the Pilot-Scale Bioreactor

Enhancing Aspergiolide A Production from A Shear-Sensitive and Easy-Foaming Marine-Derived Filamentous Fungus Aspergillus Glaucus by Oxygen Carrier Addition and Impeller Combination in A Bioreactor