Abstract:Wide-viscosity-range impellers have extensive demands and applications in process industry. The gas–liquid dispersion and mass transfer characteristics of wide-viscosity-range impellers including Large-double-blade (LDB) impeller, Fullzone (FZ) impeller and Maxblend (MB) impeller in water solutions of xanthan gum were investigated experimentally and compared. The influences of gas flow rate, impeller speed and polymer concentration of liquid on the power consumption, overall gas holdup εg and mass transfer coefficient KLa were also analyzed. On this basis, the appropriate operating parameters and impeller type were determined. The results indicate that with rising flow rate, the higher εg and KLa can be achieved with a drop in power consumption, and a relatively high flow rate is recommended on the premise of guaranteeing the complete dispersal condition in aerated vessel. Higher impeller speed provides better gas–liquid dispersion and mass transfer performance, but results in more power consumption simultaneously. The appropriate impeller speed should be just enough to meet the requirements of εg and KLa. It also is found that the increasing concentration of water solution of xanthan gum adds to the complexity of gas dispersion and mass transfer in aerated vessel. Under the same specific power consumption PV, the εg and KLa are positive and negative correlation with the polymer concentration of liquid, respectively. Specially, when the concentration of water solution of xanthan gum is relatively low, the FZ impeller exhibits the best gas dispersion and mass transfer performance under the same specific power consumption. Nevertheless, the mass transfer performance of FZ impeller deteriorates significant when the concentration of water solution of xanthan gum increases to 1.00 wt%, and the MB impeller becomes the most appropriate impeller type in this condition.

Improvement of glucoamylase production using axial impellers with low power consumption and homogeneous mass transfer

Investigation of Gas–liquid Dispersion and Mass Transfer Performance of Wide-Viscosity-range Impellers in Water Solutions of Xanthan Gum

Experimental Study on Micromixing Characteristics of Novel Large-Double-blade Impeller

Optimization of fermentation conditions for xylanase production by engineered Pichia pastoris

The effects of different impeller combinations in the Sphingan WL gum fermentation process

Power Consumption, Local and Average Volumetric Mass Transfer Coefficient in Multiple-Impeller Stirred Bioreactors for Xanthan Gum Solutions

Computational fluid dynamics simulation of different impeller combinations in high viscosity fermentation and its application]

Enhancing Aspergiolide A Production from A Shear-Sensitive and Easy-Foaming Marine-Derived Filamentous Fungus Aspergillus Glaucus by Oxygen Carrier Addition and Impeller Combination in A Bioreactor

Mass transfer performance for multiple-impeller bioreactor in cold model and fermentation experiments

The Influence of New Impeller on Xanthan Gum Fermentation

Optimization by Response Surface Methodology of Solid-state Fermentation Medium for α-Galactosidase Production by Aspergillus niger ZJUQH

A Novel Centrifugal Impeller Bioreactor. II. Oxygen Transfer and Power Consumption.

Simultaneous saccharification and ethanol fermentation at high corn stover solids loading in a helical stirring bioreactor.

High Yield And Cost-Effective Production Of Poly(Gamma-Glutamic Acid) With Bacillus Subtilis

A novel impeller configuration to improve fungal physiology performance and energy conservation for cephalosporin C production.

Mixing process of high-viscosity xanthan in different agitation system

Numerical Simulation of Power Consumption and Mixing Characteristics of Novel Large-Double-blade Impeller

High yield and cost-effective production of poly(γ-glutamic acid) with Bacillus subtilis

Dependence of fungal characteristics on seed morphology and shear stress in bioreactors

Optimization of fermentation conditions for polymalic acid production by Aureobasidium pullulans BK-10

Optimization of Curdlan Fermentation Process by Combining Impeller Combinations and Glucose Fed-Batch Modes