Optimization of flow for modified step feed process treating low COD/TN municipal sewage

Wei WANG,Qiang CHEN,Chuanxin WANG,Yongzhen PENG
DOI: https://doi.org/10.11949/j.issn.0438-1157.20150081
2015-01-01
Abstract:By adjusting the distribution ratio of influent flow into anaerobic and anoxic zones, the removal efficiency of pollutants in low C/N(COD/total nitrogen)<3.5 municipal sewage using modified step feed process was analyzed. Keeping the following conditions unchanged:hydraulic retention time (HRT) 10 h, sludge retention time (SRT) 10—15 d, volume of anaerobic zone:volume of total anoxic zones:volume of total aerobic zones 4:9:9, when the actual efficiency obtained and material balance calculation results were utilized to increase gradually the water ratio distributing to the first stage i.e. anaerobic zone, the best operating conditions could be found and 4 kinds of operating conditions determined. The results show that, at given C/N ratio, concentration of nitrogen oxides in anaerobic zone does not decrease with the increase of the water ratio entered into anaerobic zone, even appears the opposite situation. The simultaneous nitrification and denitrification(SND)and microbial assimilation effect intensity play crucial role in TN removal. The rise of water ratio entered into anaerobic zone improves the removal rate of phosphate due to the phosphorus release effect of phosphorus-accumulating bacteria is enhanced in anaerobic zone. Both nitrogen and phosphorus removals as well as subsequent optimization space are considered, one of optimized water distribution ratio is 6:3:1,and at this condition, the effluent concentration of COD, ammonia nitrogen, TN, phosphate is 45.98, 0.04,17.47 and 2.43 mg·L?1 respectively.
What problem does this paper attempt to address?