Abstract:Highly ordered TiO2 nanotube array electrodes were successfully fabricated by a two-step anodization method on Ti sheet substrates in an electrolyte composed of ammonium fluoride, deionized water, and glycol. The tube wall was smooth, and the average internal and external diameters, wall thickness, and tube length achieved were 80 nm, 90 nm, 10 nm, and 9 μm, respectively. X-ray diffraction and field emission scanning electron microscopy results revealed that the TiO2 nanotube arrays presented an amorphous structure. When calcined at 300 °C, the arrays crystallized into the anatase phase, and the crystallization degree of the oxide layer increased as the temperature rose. Calcinating at 400 °C did not obviously disrupt the porous structure of the highly ordered arrays. However, higher temperature enlarged the diameter of the nanotube array and roughened the tube wall. When the temperature reached 600 °C, the nanotube mouth broke because of the excessive stress, causing the oxide layer’s thinness and nanotube mouth clogging. The photoelectric test showed that the electrode presented obvious photoresponse under 300–400 nm UV excitation (maximized at 360 nm). The degree of crystallization and the micro-structure of the oxide layer can significantly affect the photoelectric properties of the electrode. After calcination at 400 °C, the TiO2 nanotube arrays, with highly ordered tubular structure directly connected to the Ti substrate, can ensure the rapid transportation of photo-induced electrons to the Ti substrate, while the high crystallinity of the arrays can help reduce the defect density of the nanotube and extend the lifetime of the photo-induced carriers. The electrode showed the best photoelectric property, and the photocurrent intensity was maximized (29.6 μA). However, the calcination process with over-temperature resulted in substantial loss of the TiO2 oxide layer, mouth clogging, and a severe decline in the photoelectric properties.

Preparation and Photoelectrochemical Characterization of p-Cu2O/n-TiO2 Nanotubes

Electrodeposited Cu 2 O on the {101} Facets of TiO 2 Nanosheet Arrays and Their Enhanced Photoelectrochemical Performance

Enhanced Photoelectrochemical Properties of Nanocrystalline TiO2 Electrode by Surface Sensitization with CuxO Quantum Dots

In-situ fabrication of CNT/TiO 2 interpenetrating network film on nickel substrate by chemical vapour deposition and application in photoassisted water electrolysis

Preparation and Photocatalytic Activities of TiO2 Nanotubes with Mixed Crystal Structure

Synthesis of Co3O4/Ag/TiO2 Nanotubes Arrays Via Photo-Deposition of Ag and Modification of Co3O4 (311) for Enhancement of Visible-Light Photoelectrochemical Performance

Fabrication and Photoelectrochemical Properties of CuO/TiO2 Heterojunction Nanotubes Array Film

Fabrication and characterization of photoelectrocatalytic electrodes of carbon nanotube/titanium oxide

Preparation of High Efficient Photoelectrode of N–F-codoped TiO2 Nanotubes

One-Step Fabrication of Cds Nanoparticle-Sensitized Tio2 Nanotube Arrays Via Electrodeposition

Fabrication of Cu2o/Tio2 Nanotube Heterojunction Arrays and Investigation of Its Photoelectrochemical Behavior

Facile Preparation Carbon-Doped TiO2 Nanotube Electrodes and Its Enhanced Photoelectrochemical Response

Optimization of Cds/Tio2 Nanotube-Array Composite Photocatalysts Prepared by Electrodeposition

Study on Fabrication and UV Photoelectric Property of TiO2 Nanotube Array Electrodes.

Ag and Cu2O bimetal co-modified TiO2 nanotubes with enhanced photocatalytic performance

Coupling between the photoactivity and CO2 adsorption on rapidly thermal hydrogenated vs. conventionally annealed copper oxides deposited on TiO2 nanotubes

Characterization of CNT/TiO2Electrode Prepared Through Impregnation with TNB and Their Photoelectrocatalytic Properties

Preparation and characterization of visible-light-sensitive anodic Cu-Ti-O nanotube arrays

Electro-Chemical Preparation of Tio2/Cnt Electrodes with Tnb Electrolyte and Their Photoelectrocatalytic Effect

Photoelectrocatalytic Oxidation of Cu-cyanides and Cu-EDTA at TiO2 nanotube electrode

Photoelectrocatalytic Oxidation of Cu-cyanides and Cu-EDTA at TiO 2 nanotube electrode