Enhanced Photoelectrochemical Performance of Co/TiO2Nanotubes Prepared by Electrodeposition
Xueqin Wang,Man Dai,Qihui Chen,Peng Qiao,Ying Liu,Wenyi Wang,Yuanyuan Wang,Hua Song
DOI: https://doi.org/10.1142/s1793292022501016
2022-01-01
NANO
Abstract:TiO2nanotube arrays (NTbs) have been widely used in the field of photocatalysis due to their large surface area, good controllability and superior electron transport properties. However, due to its wide bandgap (3.2[Formula: see text]eV), pure TiO2can only be excited by ultraviolet light ([Formula: see text][Formula: see text]nm), leading to low utilization of solar energy. Second, the high recombination rate of the photogenerated electrons and holes ([Formula: see text]/[Formula: see text] pair also reduces the quantum efficiency of TiO2. In order to realize the efficient photocatalytic activity of TiO2nanomaterials, it is necessary to design the TiO2nanomaterials to optimize the utilization of the solar spectrum. In this study, TiO2NTbs were obtained by the anodizing method using titanium foil, and a series of Co/TiO2NTbs were prepared by electrochemical deposition. The effects of the deposition voltage on the physical and photocatalytic properties of the Co/TiO2NTbs were investigated. Results found that the Co/TiO2NTbs had the highest photocurrent density 0.7[Formula: see text]mA/cm2at an electrodeposition time of 60[Formula: see text]s and a voltage of 1[Formula: see text]V, and the photoelectric conversion efficiency was 15.85%, which was approximately 2.8 times that of the pure TiO2NTbs. The degradation rate of Rhodamine B of the Co/TiO2NTbs in 120[Formula: see text]min was 76.3%, whereas that of the pure TiO2NTbs was only 48.7%. The forbidden bandwidth of the Co/TiO2NTbs was reduced to 3.02[Formula: see text]eV, whereas that of the pure TiO2NTbs was 3.2[Formula: see text]eV.