Abstract:TiO2 is widely considered as one of the promising materials to fulfill photoelectrochemical water splitting requirements for its low cost, nontoxicity, photostablity, and strong photo oxidation ability. Several synthesis approaches have been reported to fabricate TiO2 nanostructures, including template assisted hydrothermal, anodization, and sol-gel. Among them, anodization method is capable of producing highly ordered, well aligned TiO2 nanotubes (NTs) with controlled diameters and tube length. The unidirectional tubular structure provides the charge transport channels from electrolyte/photoanode interface to conductive substrate. The intrinsic band gap of TiO2 (3.2eV for anatase and 3.0eV for rutile), however, limits its optical absorption only within UV region. The rapid recombination rate of photo-excited electrons and holes also severely hinders its practical application.1 Many approaches have been developed to promote the photo response of TiO2 in visible light region. For example, by hetero coupling, the holes and electrons can be photo excited from the narrow-gap semiconductor and separated effectively, which significantly promotes the visible light response. To form hetero coupling, cobalt oxide, a typical P-type semiconductor with band gap of ~2.1eV is chosen. Recent report shows cobalt oxide coupled with TiO2 exhibit could enhance the photo oxidation activity under visible light illumination.2 CoOx/TiO2 nanoparticles also show great photocatalytic activity on water splitting. Here we report the formation of CoOx/TiO2 NTs hetero coupling by atomic layer deposition (ALD). ALD is ultrathin film deposition technique to have sub-nanometer control of film thickness. As a promising method to passivate and modify photoanode,3 ALD could form chemical bonds on substrate and operate at a relatively low temperature. We will show that by uniformly depositing a layer of cobalt oxide film onto the TiO2 nanotubes, CoOx/TiO2 NTs system exhibits one fold improvement on photocurrent response under visible light illumination compared with pristine TiO2 NTs, and about two times the efficiency of CoOx/TiO2 synthesized via wet-chemistry method. The structure was detailed studied and optimized, and mechanism will also be discussed. References: 1. S. Kurian, H. Seo and H. Jeon, The Journal of Physical Chemistry C, 2013, 117, 16811-16819. 2. T. Q. Ngo, A. Posadas, H. Seo, S. Hoang, M. D. McDaniel, D. Utess, D. H. Triyoso, C. B. Mullins, A. A. Demkov and J. G. Ekerdt, Journal of Applied Physics, 2013, 114, 084901-084908. 3. S. C. Riha, B. M. Klahr, E. C. Tyo, S. Seifert, S. Vajda, M. J. Pellin, T. W. Hamann and A. B. F. Martinson, Acs Nano, 2013, 7, 2396-2405.

In-situ fabrication of CNT/TiO 2 interpenetrating network film on nickel substrate by chemical vapour deposition and application in photoassisted water electrolysis

A new fabrication method of uniformly distributed TiO2/CNTs composite film by in-situ chemical vapordeposition

Facile Fabrication of Three-Dimensional Interconnected Nanoporous N-TiO 2 for Efficient Photoelectrochemical Water Splitting

Self-supported Film Catalyst Integrated with Multifunctional Carbon Nanotubes and Ni-Ni(OH)2 Heterostructure for Promoted Hydrogen Evolution

Fabrication of CNT/TiO2 electrodes and their photoelectrocatalytic properties for methylene blue degradation

Fabrication and characterization of photoelectrocatalytic electrodes of carbon nanotube/titanium oxide

Enhanced photoelectrochemical water splitting activity of carbon nanotubes@TiO2 nanoribbons in different electrolytes

Photoelectrochemical performance of TiO2 nanotube arrays modified with Ni2P Co-catalyst

Electro-Chemical Preparation of Tio2/Cnt Electrodes with Tnb Electrolyte and Their Photoelectrocatalytic Effect

Nickel-based thin film on multiwalled carbon nanotubes as an efficient bifunctional electrocatalyst for water splitting.

Enhanced Photoelectrocatalytic Degradation of Ammonia by in Situ Photoelectrogenerated Active Chlorine on TiO2 Nanotube Electrodes.

Characterization of CNT/TiO2Electrode Prepared Through Impregnation with TNB and Their Photoelectrocatalytic Properties

Preparation of High Efficient Photoelectrode of N–F-codoped TiO2 Nanotubes

Fabrication and Characterization of Cu/Ti Bilayer Nanoelectrode for Electrochemical Denitrification

Fabrication and Photoelectrochemical Properties of CuO/TiO2 Heterojunction Nanotubes Array Film

Fabrication of MnO2/TiO2 nano-tube arrays photoelectrode and its enhanced visible light photoelectrocatalytic performance and mechanism

Preparation and hydrogen evolution performance of porous Ni-Cu-Ti/CNTs-Ni electrode

Synthesis and Characterization of Cnt / Tio2 Photoelectrocatalytic Electrodes for Methlene Blue Degradation

A Freestanding Single-Wall Carbon Nanotube Film Decorated with N-Doped Carbon-Encapsulated Ni Nanoparticles as a Bifunctional Electrocatalyst for Overall Water Splitting

Electrochemical performance of TiO 2 /carbon nanotubes nanocomposite prepared by an in situ route for Li-ion batteries

Enhanced Visible-Light Photoelectrochemical Performance of Titana Nanotubes Modified by Atomic Layer Deposited Cobalt Oxide