Abstract:The soil-water characteristic curve (SWCC) is defined as the relationship between the suction and the water content or degree of saturation. The soil-water characteristics and related mathematical models can be used to model the unsaturated soil properties such as the permeability and the shear strength. Conventionally, only the drying soil-water characteristic curve of soil is determined. In this work, the influences of initial water content, initial dry density, the vertical stress and drying and wetting cycles are examined and discussed in detail. The SWCCs and hysteresis loops of residual soils in Xiamen were obtained by the filter paper method. The results show that the initial water content has negligible effect on SWCCs. The specimen at the wet of optimum moisture content (OMC) has the higher air entry value and the larger hysteresis loop than that of the soil specimen at the dry of OMC. The specimen with OMC lies between them. While, the initial dry density has considerable influence on SWCCs. The specimen at lower initial dry density exhibits smaller air entry value and higher rate of desorption than that of the specimen at higher initial dry density. The size of hysteresis loop decreases as the initial dry density increases. The specimens subjected to different vertical stresses have different SWCCs. The higher the applied load on the specimen, the higher the air entry value, the higher the rate of desorption, the smaller the size of hysteresis loop. In the drying and wetting process, the size of hysteresis loop has been substantially affected by the first drying and wetting cycle. With the increasing of drying and wetting cycle, the air entry value and the size of hysteresis hoop decrease. Since the features of soil-water characteristic of sandy clay are not well defined especially for the residual state of saturation, which desaturates continuously without a distinct break point, the residual suction or residual water content, one of the key parameters in the mathematical models of SWCC, is not well defined. As a result five improved models without the residual water content are proposed to describe the SWCCs of residual soil. The improved Gardner model has been found to be the most suitable model for all SWCCs of the residual sandy clay in Xiamen.

Mathematical Model on Formula and Properties of Water Swelling Rubber

Percolation Analysis on the Effect of the Modified Components on the Water Swellable Property of Water Swellable Rubber

Influences Affecting the Soil-Water Characteristic Curve

Influence of reinforcing filler on water swelling rubber

Research on Real-Time Soft Measuring State Parameters of Rubber Dam Inflated by Water

Influence of Super Absorbent Resin's Particle Size on Properties of Water Swelling Rubber

Study of Preparation and Environmental Resistence of Water Swellable Rubber

Progress in water swellable rubber

Experiment And Modeling Of Soil-Water Characteristic Curve Of Unsaturated Residual Soil

The Research Development of Water-Swellable Rubber

Effect of Swelling Behavior of Rubber Rings on the Sealing Performance for 70MPA Hydrogen Pressure Reducing Valves

Establishment of Constitutive Model of Silicone Rubber Foams Based on Statistical Theory of Rubber Elasticity

Method for Predicting the Water Absorption of External Insulating Silicone Rubber

Mechanical properties, water swelling behavior, and morphology of swellable rubber compatibilized by PVA-g-PBA

A quantitative description method for the mechanical behavior of soil-rock mixture as affected by water content

The mathematic models of compounding characteristics of non-sulfur modified powdered polychloroprene rubber

Study on the Model Selection of Water Diffusion into Silicone Rubber by NMR and Gravimetric Technique

Preparation and Properties of Oil Swelling Polymerized Styrene Butadiene Rubber

Modeling and simulation for the swelling behavior of unvulcanized rubber during the calendering process

Preparation and Performance of Water Absorption Rubber with Binary Interpenetrating Networks and Montmorillonite

Investigation on the Swelling Property of Rubber in Asphalt