Abstract:Natural rubber (NR) was self‐reinforced by mixing partially vulcanized NR (PNR) and then further normally vulcanization together. The PNR could be in situ fiberized and co‐vulcanized with the NR matrix and form a network with well‐bonded interface. As a result, the self‐reinforced NR (SNR) composites have excellent tear strength and other good mechanical performance including high elongation at break due to high elasticity of the PNR after complete vulcanization. In the contemporary modern mining sector, rubber conveyor belts are extensively and frequently utilized. Exceptional tear resistance and high elongation of the top cover rubber of the belt are imperative. In this investigation, a portion of natural rubber (NR) underwent partial vulcanization in advance. Subsequently, this pre‐vulcanized NR (PNR) was mixed with the NR matrix via mechanical blending. Due to the increased viscosity resulting from pre‐vulcanization, the PNR may disperse in the NR matrix, maintaining a specific microstructure without complete dissolution. During subsequent vulcanization, the PNR could co‐vulcanize with the NR matrix, forming a well‐bonded interface and ultimately yielding self‐reinforced NR (SNR) composites. The influences of the mass ratio of PNR to the NR matrix, sulfur content in PNR and pre‐vulcanization time on the mechanical properties of the SNR composites were thoroughly investigated. The results indicated that adding PNR effectively improved the tear strength of NR. When the PNR replaced 20 wt% of NR, sulfur content in PNR was 2.4 phr and pre‐vulcanization time was 2 min, the tear strength, stress at 300% elongation and wear resistance of SNR composites increased by 34.1%, 16.6%, and 10.2% compared to NR control sample, while elongation at break remained at 898%. These findings suggest that it is possible to enhance the tear strength of rubber without compromising elongation at break.

Study of Preparation and Environmental Resistence of Water Swellable Rubber

Mechanical properties, water swelling behavior, and morphology of swellable rubber compatibilized by PVA-g-PBA

Preparation and Performance of Water Absorption Rubber with Binary Interpenetrating Networks and Montmorillonite

Study of swelling properties of nitrile rubber with orthogonal test

Preparation of high-quality wollastonite/natural rubber composites by atomization sputtering rapid drying process

PROPERTIES OF WATER-SWELLABLE COMPOUNDS BASED ON NITRILE RUBBER WITH VARIED ACRYLONITRILE CONTENT

Superior wave-absorbing performances of silicone rubber composites via introducing covalently bonded SnO<sub>2</sub>@MWCNT absorbent with encapsulation structure

Research Progress of Natural Rubber Wet Mixing Technology

Study of Swellable Water-Plugging Agents with Heat- and Hard-water Resistances

Preparation and Characterization of High-Performance Natural Rubber Latex Composites with Sodium Methylene Bis-naphthalene Sulfonate Modified Multiwalled Carbon Nanotubes

Wormwood-infused porous-CaCO3 for synthesizing antibacterial natural rubber latex

Monitoring performance analysis of composite chemical rubber materials under environmental pollution conditions based on nanomaterials chemical sensors

Preparation of High-Performance Composite Hydrogel Reinforced by Hydrophilic Modified Waste Rubber Powder

Interaction between swelling behavior and erosion resistance of nitrile-butadiene rubber vulcanizates in sodium chloride solution

Preparation and mechanical properties of water‐dispersible hyperbranched polymer grafted carbon black/natural rubber composites by latex blending method

Preparation and application of carbon black-filled rubber composite modified with a multi-functional silane coupling agent

Enhancing Interface Adhesion Between Waterjet‐produced Rubber Powders and Natural Rubber by Wet‐mixing Method

Absorption and Permeation of Water and Aqueous Solutions of High-Temperature Vulcanized Silicone Rubber

Preparation and Properties Research of Oil-absorbing Rubber

Self‐reinforced natural rubber composites: Preparation and properties study

Design and preparation of novel silicon rubber with homogeneous crosslinking network and its application in high-performance SR/EPDM blend