Abstract:Vortex-Induced Vibrations (VIVs) of a near-wall cylinder involve complex interactions between the structure and the boundary layers in the shear flow. Based on dimensional analyses, the wall-proximity effects on the triggering of transverse VIVs of a circular cylinder are physically investigated with flume observations. An accessorial low structural-damping VIV simulation device was developed and an upward-illumination Particle Image Velocimetry (PIV) system was employed in the physical modeling. Although the regular Kármán-like vortex-shedding could be suppressed for small gap-to-diameter ratios (e.g., e/D < 0.40) as reported in previous studies, the present power spectral analyses on the velocity fluctuations in the lee-wake indicate that the characteristic frequency can still be well identified, which could further trigger the vibrations of a low mass-damping cylinder. PIV measurements show that, as the cylinder approaches the bottom, the asymmetry of swirling-strengths in the lee-wake gets more remarkable, and the values of Strouhal number increase correspondingly. Four typical stages can be identified in the process of the vibration being triggered under the wall-free condition, including (a) the fully-stationary, (b) the intermittent-vibrating, (c) the sharp-jump, and (d) the upper-branch vibration stages. But, for e/D ≤ 0.20, the intermittent-vibrating stage disappeared. During the sharp-jump stage, the peak jump-amplitude decreases dramatically as the cylinder approaches the bottom, which has negative correlation with the vibration frequency. The effects of the swirling-strength attenuation and the downward collisions on the vibration responses are discussed. The relationship between critical reduced velocity V r cr and e/D is finally established by fitting the experimental results. It is indicated that the wall-proximity effects could be significant and should be taken into account while evaluating the critical velocity for triggering transverse vibrations of the near-wall cylinder in the engineering practices.

Vibration characteristics of wallboard and four-bar linkage beating-up mechanism of air-jet loom

Investigation of Noise Characteristics of Electric Vibrator Utilizing Acoustic Camera and Transfer Path Analysis

Dynamics Analysis and Simulation of Beating-up Motion of a Rapier Loom

Vibration Tests and Crack Analyses on Multi-Storeys Industrial Factory Buildings

Analysis of Reed-Base's Front Extreme Position for Four-Bar Beating-Up Linkage

Damping Property of Free Vibration for Office Equipment Paper

Numerical solution for the dynamic response of a two-side four-bar beating-up motion of an air-jet loom

Simulation Analysis of Wall Plastering Machine Vibration Compaction Process Based on LS-Dyna

Measurement and Analysis of the Vibration Responses of Piano Soundboards with Different Structures

Dynamics Analysis of Mass Block and Optimization Design of Take-up Mechanism for Space Net

ANALYSIS OF VIBRATION CHARACTERISTICS FOR RUBBING MACHINE BASED ON MODAL TEST

Damping Technology Used in Nonwoven Needle Loom

Study on stiffness matching strategy of longitudinal sleeper and fastener to reduce tunnel wall vibration

Research on Testing Method of Dynamic Strain on the Wallboard of Printing Press

Improvement of the Warp Loosing Motion and its Static Analysis of the Back Rest System for an Air-jet Loom

Experimental Study on Dynamic Performance of Viscous Damping Wall

Experimental Modal Analysis of Horizontal Machine Tools

Vibration analysis of BX32-20/2T2-100 reciprocating compressor

TESTING RESEARCH ON VIBRANT ACCELERATION OF POINT MACHINE

Simulation Analysis of Boiler Air Duct Vibration

Triggering mechanics for transverse vibrations of a circular cylinder in a shear flow: Wall-proximity effects