Abstract:On the basis of previous experimental studies of two-phase flow condensation heat transfer for R134a inside the horizontal micro-fin tubes, a theoretically analysis of heat transfer characteristic combining both heat transfer mechanism and flow mechanism is discussed by the experimental data of heat transfer coefficient and pressure drop, to further clarify the influence of experimental condition and tube structure on heat transfer characteristics under the special working condition. Two performance factors, enhancement factor (EF) and penalty factor (PF), are introduced to quantitatively compare the effect of micro-fin on the heat transfer coefficient and the pressure drop between enhance tube and smooth tube. Meanwhile, the comprehensive factor, CHF, is applied to evaluate the comprehensive performance of heat transfer tube. It was found that enhancement factor (EF) and penalty factor (PF) both increase with increasing mass flux and fin helical angle, and decreasing saturation temperature, the comprehensive factor, CHF, is always greater than one and increases with increasing fin helical angle and mass flux, and decreasing saturation temperature. Moreover, based on the comparative analysis findings that some existing correlations of heat transfer characteristics underestimate most of the experimental data, and the experimental variable has great influences on the correlation prediction accuracy, such as mass flux, which is proportionate to the prediction deviation of correlation. Therefore, a new correlation was developed through analyzing quantitatively influencing mechanism of the experimental variable on the heat transfer characteristics, in a way that a two-phase frictional multiplier is defined firstly from the experimental data and then the forced convection heat transfer mechanism is redefined based on the comprehensive effect of various experimental variables. By the experimental data verification, the new correlation shows good prediction effect with the mean deviation of less than 5%.

Thermal calculation method for direct-contact flue-gas-water condensation heat exchangers

Heat transfer performance of direct-contact flue-gas condensation heat exchanger

A Calculational Method for Heat Transfer Coefficient of Phosphoric Furnace by Hot Process

Flue gas-water direct-contact heat transfer performances

A thermal calculation model for tubular condensing heat exchanger

Performances Of Gas-Water Direct-Contact Heat Transfer

A numerical study on convective condensation of flue gas in tubular heat exchangers

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experiment on Forced Convection-Condensation Heat Transfer Characteristics Based on Finned Plate Configuration

General numerical method for hydraulic and thermal modelling of the steam superheaters

Investigation of the condensation heat-transfer between the wet air and 3-D finned-tube heat exchanger surface with different anti-corrosion coatings

Condensation in Horizontal Smooth Tubes: A New Heat Transfer Model for Heat Exchanger Design

Calculation of Thermal Efficiency During Flue Gas Condensation of Natural Gas and Analysis of Influence Factor

Airside Thermal–hydraulic Performance Evaluation of Flue Gas Coolers for Waste Heat Recovery

Numerical investigation of condensation characteristics of a moist air-to-air plate-fin heat exchanger and experimental validation

Numerical investigation on acid vapor condensation characteristics of honeycomb H-type finned tube heat exchangers with hexagonal fins

ANALYSIS OF THE THERMAL PERFORMANCE OF DIRECT-CONTACT AIR-CONDITIONING SYSTEMS

Experimental Study of the Condensation Heat Transfer Performance of Flue Gases in a Heating-and-power Cogeneration System

A Correction Factor-Based General Thermal Resistance Formula for Heat Exchanger Design and Performance Analysis

Thermal analysis and performance investigations of shell and tube heat exchanger using numerical simulations